Gigabyte GA-X38-DQ6 User Manual page 86

3. Assign Array Disks: After a RAID mode is selected, RAID BIOS automatically assigns the two
hard drives installed as the RAID drives.
4. Set Block Size (RAID 0 only): Under the Block item, use the up or down arrow key to select the
stripe block size (Figure 6), ranging from 4 KB to 128 KB. Press <Enter>.
GIGABYTE Technology Corp. PCIE-to-SATAII/IDE RAID Controller BIOSv1.06.59
[ Create New RAID ]
Name: GRAID
Level: 0-Stripe
Disks: Select Disk
Block: 128 KB
Size: 240 GB
Confirm Creation
[ RAID Disk Drive List ]
[ ]-Switch RAID Block Size
5. Set Array Size: Under the Size item, enter the size of the array and press <Enter>.
6. Confirm Creation: After all of the items above are configured, the selection bar automatically jumps
to the Confirm Creation item. Press <Enter>. When prompted to confirm your selection (Figure 7),
press <Y> to confirm or <N> to abort.
GIGABYTE Technology Corp. PCIE-to-SATAII/IDE RAID Controller BIOSv1.06.59
[ Create New RAID ]
Name: GRAID
Level: 0-Stripe
Disks: Select Disk
Block: 128 KB
Size: 240 GB
Confirm Creation
[ RAID Disk Drive List ]
[ ]-Switch Unit
GA-X38-DQ6 Motherboard
[ Hard Disk Drive List ]
Model Name
HDD0:
HDD1:
[ Help ]
Select a stripe size which will be used to
divide data from/to seperate RAID members.
The following are typical values:
[ENTER]-Next
Figure 6
[ Hard Disk Drive List ]
Model Name
HDD0:
HDD1:
[ Help ]
Create RAID on the select HDD(Y/N)?Y
ALL DATA ON THE SELECTED HARD DISK
WILL BE LOST WHEN EXIT WITH SAVING
[DEL,BS]-Delete Number
Figure 7
- 86 -
Available
ST3120026AS 120 GB
ST3120026AS 120 GB
Setting Stripe Block
RAID 0-128KB
[ESC]-Abort
Available
ST3120026AS 120 GB
ST3120026AS 120 GB
CONFIRM RAID CREATION
[ENTER]-Next [ESC]-Abort
Type/Status
Non-RAID
Non-RAID
Type/Status
Non-RAID
Non-RAID