Table of Contents
Advertisement
Quick Links
User Manual
900 Ceramic Cooktop Touch - Slide
AUPL-CT90
IMPORTANT
Please ensure that you read through this manual prior to installation and use. This user
manual contains important information to ensure optimal performance and keep you safe.
Please retain your proof of purchase, as this will be needed in the event that you require a
warranty service. Remember to keep this user manual for future reference.
| platinumappliances.com.au
Advertisement
Table of Contents
Related Manuals for Platinum AUPL-CT90
Summary of Contents for Platinum AUPL-CT90
- Page 1 User Manual 900 Ceramic Cooktop Touch - Slide AUPL-CT90 IMPORTANT Please ensure that you read through this manual prior to installation and use. This user manual contains important information to ensure optimal performance and keep you safe. Please retain your proof of purchase, as this will be needed in the event that you require a warranty service.
-
Page 3: Table Of Contents
Content 1. Foreword ..................3 1.1 Safety Warnings ................3 1.2 Installation ................. 3 1.2.1 Electrical Shock Hazard ........... 3 1.2.2 Cut Hazard ..............3 1.2.3 Important safety instructions ........... 3 1.3 Operation and maintenance ............4 1.3.1 Electrical Shock Hazard ........... 4 1.3.2 Health Hazard ............... - Page 4 4. Cooking Guidelines ................ 13 4.1 Cooking Tips ................13 4.1.1 Simmering, cooking rice ..........13 4.1.2 Searing steak .............. 13 4.1.3 For stir-frying .............. 14 5. Heat Settings ................. 14 6. Care and Cleaning ................14 7. Hints and Tips ................15 8.
-
Page 5: Foreword
1. Foreword 1.1 Safety Warnings Your safety is important to us. Please read this information before using your cooktop. 1.2 Installation 1.2.1 Electrical Shock Hazard • Disconnect the appliance from the mains electricity supply before carrying out any work or maintenance on it. •... -
Page 6: Operation And Maintenance
• Failure to install the appliance correctly could invalidate any warranty or liability claims. 1.3 Operation and maintenance 1.3.1 Electrical Shock Hazard • Do not cook on a broken or cracked cooktop. If the cooktop surface should break or crack, switch the appliance off immediately at the mains power supply (wall switch) and contact a qualified technician. -
Page 7: Important Safety Instructions
• Failure to use caution could result in injury or cuts. 1.3.5 Important safety instructions • Never leave the appliance unattended when in use. Boilover causes smoking and greasy spillovers that may ignite. • Never use your appliance as a work or storage surface. •... - Page 8 • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • This appliance is intended to be used in household and similar applications such as: -staff kitchen areas in shops, offices and other working environments;...
-
Page 9: Product Introduction
Congratulations on the purchase of your new Ceramic Hob. We recommend that you spend some time to read this Instruction / Installation Manual in order to fully understand how to install correctly and operate it. For installation, please read the installation section. Read all the safety instructions carefully before use and keep this Instruction / Installation Manual for future reference. -
Page 10: Before Using Your New Ceramic Hob
Read this guide, taking special note of the ‘Safety Warnings’ section. • Remove any protective film that may still be on your ceramic hob. 2.6 Technical Specification Cooking Hob AUPL-CT90 Cooking Zones 5 Zones Supply Voltage 220-240V~ 50Hz Installed Electric Power... -
Page 11: How To Use
Always lift pans off the ceramic hob – do not slide, or they may scratch the glass. 3.3 How to use 3.3.1 Start cooking After power on, the buzzer beeps once, all the indicators light up for 1 second then go out, indicating that the ceramic hob has entered the stat of standby mode. -
Page 12: Locking The Controls
Turn the cooking zone off by touching the slider to ” l ”. Make sure the display shows ”0” Turn the whole cooktop off by touching the ON/OFF control. Beware of hot surfaces “H” will show which cooking zone is hot to touch. It will disappear when the surface has cooled down to a safe temperature. -
Page 13: Timer Control
Press the heating zone selection control of the double loop heating zone (e.g. 6,) The power level indicator flash, then press “ ” , after 5 seconds, the indicator stop flash, the double loop function is activate, and power level shows “6” and “=” alternately. Deactivate the Double zone Press the heating zone selection control of the double loop heating zone, the power level indicator flash. -
Page 14: Setting The Timer To Turn One Cooking Zone Off
Touch timer control again, the “1” will flash. Set the time by touching the slider control (e.g.9), now the timer you set is 95 minutes. When the time is set, it will begin to count down immediately. The display will show the remaining time Buzzer will beep for 30 seconds and the timer indicator shows “- -”... -
Page 15: Over-Temperature Protection
3.3.6 Over-Temperature Protection A temperature sensor equipped can monitor the temperature inside the ceramic hob. When an excessive temperature is monitored, the ceramic hob will stop operation automatically. 3.3.7 Residual Heat Warning When the hob has been operating for some time, there will be some residual heat. The letter “... -
Page 16: For Stir-Frying
4.1.3 For stir-frying 1. Choose an ceramic compatible flat-based wok or a large frying pan. 2. Have all the ingredients and equipment ready. Stir-frying should be quick. If cooking large quantities, cook the food in several smaller batches. 3. Preheat the pan briefly and add two tablespoons of oil. 4. -
Page 17: Hints And Tips
Boilovers, melts, and Remove these immediately with • Remove stains left by melts and hot sugary spills on a fish slice, palette knife or razor sugary food or spillovers as soon the glass blade scraper suitable for as possible. If left to cool on the Ceramic glass cooktops, but glass, they may be difficult to beware of hot cooking zone... -
Page 18: Installation
Some pans make This may be caused by the This is normal for cookware and crackling or clicking construction of your cookware does not indicate a fault. noises. (layers of different metals vibrating differently). 8. Installation 8.1 Selection of installation equipment Cut out the work surface according to the sizes shown in the drawing. -
Page 19: Before Locating The Fixing Brackets
WARNING: Ensuring Adequate Ventilation Make sure the ceramic hob is well ventilated and that air inlet and outlet are not blocked. In order to avoid accidental touch with the overheating bottom of the hob, or getting unexpected electric shock during working, it is necessary to put a wooden insert, fixed by screws, at a minimum distance of 50mm from the bottom of the hob. -
Page 20: Cautions
Adjust the bracket position to suit for different work surface’s thickness. TABLE TABLE BLACKET BLACKET Under any circumstances, the brackets cannot touch with the inner surfaces of the worktop after installation (see picture) 8.3 Cautions 1. The ceramic cooker hob must be installed by qualified personnel or technicians. We have professionals at your service. - Page 21 Yellow / Green Black Brown Blue 1. If the cable is damaged or needs replacing, this should be done by an after-sales technician using the proper tools, so as to avoid any accidents. 2. If the appliance is being connected directly to the mains supply, an omnipolar circuit breaker must be installed with a minimum gap of 3mm between the contacts.
- Page 22 Notes...
- Page 23 Notes...
- Page 24 Platinum Appliances PO Box 7785 1300 985 815 customercare@platinumappliances.com.au platinumappliances.com.au Platinum is committed to ongoing research to ensure all information in this user manual is correct at time of going to print. Dimensions product only. Manufacturers reserves the right to change...
Need help?
Do you have a question about the AUPL-CT90 and is the answer not in the manual?
Questions and answers