B. Updating the BIOS
When updating the BIOS, choose the location where the BIOS file is saved. The follow procedure
assumes that you save the BIOS file to a floppy disk.
Step 1:
1. Insert the floppy disk containing the BIOS file into the floppy disk drive. In the main menu of Q-
Flash, use the up or down arrow key to select Update BIOS from Drive and press <Enter>.
• The Save Main BIOS to Drive option allows you to save the current BIOS file.
• Q-Flash only supports USB flash drive or hard drives using FAT32/16/12 file system.
• If the BIOS update file is saved to a hard drive in RAID/AHCI mode or a hard drive
attached to an independent IDE/SATA controller, use the <End> key during the POST to
access Q-Flash.
2. Select Floppy A and press <Enter>.
3. Select the BIOS update file and press <Enter>.
Make sure the BIOS update file matches your motherboard model.
Step 2:
The process of the system reading the BIOS file from the floppy disk is displayed on the screen. When
the message "Are you sure to update BIOS?" appears, press <Enter> to begin the BIOS update. The
monitor will display the update process.
• Do not turn off or restart the system when the system is reading/updating the BIOS.
• Do not remove the floppy disk, USB flash drive, or hard drive when the system is updating
the BIOS.
Step 3:
When the update process is complete, press any key to return to the main menu.
Flash Type/Size.................................MXIC 25L8005
Keep DMI Data
Update BIOS from Drive
Floppy A
Enter : Run
:Move
HDD 0-0
Total size : 0
Flash Type/Size..................................MXIC 25L8005
Keep DMI Data
Update BIOS from Drive
!! Copy BIOS completed - Pass !!
Please press any key to continue
Enter : Run
:Move
Q-Flash Utility v2.05
Enable
Save BIOS to Drive
0 file(s) found
<Drive>
ESC:Reset
<Drive>
Free size : 0
Q-Flash Utility v2.05
Enable
Save BIOS to Drive
ESC:Reset
- 71 -
1M
F10:Power Off
1M
F10:Power Off
Unique Features