Gigabyte GA-965QM-DS2 User Manual page 57

Intel coretm 2 extreme quad-core / coretm 2 quad / intel coretm 2 extreme dual-core / coretm 2 duo / intel pentium processor extreme edition / intel pentium d / pentium 4 lga775 processor motherboard
Table of Contents

Advertisement

c . Select the BIOS file and press ENTER.
Make sure again the BIOS file matches your motherboard model.
Step 2: The process of system reading the BIOS file from the floppy disk is displayed on the screen.
When the message "Are you sure to update BIOS?" appears, press ENTER. The BIOS update
will begin and the current process will be displayed.
1. Do not turn off or restart the system when the system is reading/updating the BIOS.
2. Do not remove the floppy disk or hard drive/USB drive when the system is updating the BIOS.
Step 3: When the update process is complete, press any key to return to the Q-Flash main menu.
Flash Type/Size.................................Winbond 25X80
Step 4: Press ESC and then DELETE to exit Q-Flash and the system will restart. As the system reboots,
you will see the new BIOS version during POST.
Step 5: As the system reboots, press DELETE to enter BIOS Setup. Select Load Optimized Defaults
and press ENTER to load BIOS defaults. System will re-detect all peripherals devices after
BIOS update, so we recommend that you reload BIOS defaults.
CMOS Setup Utility-Copyright (C) 1984-2006 Award Software
Standard CMOS Features
Advanced BIOS Features
Integrated Peripherals
Power Management Setup
PnP/PCI Configurations
PC Health Status
Frequency/Voltage Control
Esc: Quit
F8: Q-Flash
Step 6: Select Save & Exit Setup and then press Y to save settings to CMOS and exit BIOS Setup.
When the system restarts, the whole update process is complete.
Q-Flash Utility v2.02
Keep DMI Data
Update BIOS from Drive
!! Copy BIOS completed - Pass !!
Save BIOS to Drive
Please press any key to continue
Enter : Run
:Move
Load Optimized Defaults (Y/N)? N
: Select Item
F10: Save & Exit Setup
Load Optimized Defaults
Press Y to load BIOS defaults
- 57 -
1M
Enable
ESC:Reset
F10:Power Off
Security Chip Configuration
Load Fail-Safe Defaults
Load Optimized Defaults
Set Supervisor Password
Set User Password
Save & Exit Setup
Exit Without Saving
F11: Save CMOS to BIOS
F12: Load CMOS from BIOS
Appendix

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents