Configuring The Printer For The Network With The Control Panel - Gestetner P7145 Setup Manual

3. Configuring the Printer for
Configuring the Printer for the Network
with the Control Panel
After installing the optional Network
Interface Board, configure it for the
network using the printer's control
panel.
Configure the printer for the network
using the printer's control panel.
The following table shows the control
panel settings and their default set-
tings. These are included in the "Host
Interface" menu.
Reference
For information about configuring
the computer for the network, see
the Network Printing Guide on the
CD-ROM labeled "Operating In-
structions".
For information about "Host Inter-
face" menu, see "Host Interface
Menu" in the Printer Reference on
the CD-ROM labeled "Operating
Instructions".
Setting Name
IP Address
Subnet Mask
Gateway Address
Network Boot
Frame Type (NW)
(Frame type Net-
Ware)
Active Protocol
Ethernet
❍ means that this protocol is active.
*1
Value
011.022.033.044
000.000.000.000
000.000.000.000
None
Auto
❍
*1
TCP/IP
❍
*1
NetWare
❍
*1
NetBEUI
❍
*1
AppleTalk
Auto
the Network
A A A A
Press { { { { Menu} } } } .
"Menu" appears on the panel dis-
play.
B B B B
Press { { { { U U U U } } } } or { { { { T T T T } } } } to display "Host
Interface" menu.
Menu:
Host Interface
C C C C
Press { { { { Enter #} } } } .
The following message appears on
the panel display.
Host Interface:
I/O Buffer
31