Table of Contents
Advertisement
Chapter 2. Installation Guide
2.1 Hardware Installation
There are two ways to install the Adapter:
1. Plug the Adapter directly to the USB port on your computer.
2. Connect the Adapter and your computer through the USB cable attached in package.
Note:
The promoted Found New Hardware Wizard screen will pop up when the adapter is installed
correctly. Click Cancel.
2.2 Software Installation
2.2.1 For Windows XP
The Setup steps for Windows 2000 and XP are similar with each other. This user guide takes
Windows XP for example.
1.
Insert the Resource CD into your CD-ROM drive, and then Figure 2-1 will appear. To
continue, select the TL-WN821N. There will be a menu including Install Driver & Utility,
QSS Installation and User Guide.
2.
Click Install Driver & Utility to load the following screen.
TL-WN821N
300Mbps Wireless N USB Adapter
Figure 2-1
4
Advertisement
Table of Contents
Need help?
Do you have a question about the TD-W300KIT and is the answer not in the manual?
Questions and answers