Page 1
User Manual WSnow22T 48V - Tool Only 22- 22-in. Snow Blower DO NOT RETURN THIS PRODUCT TO THE STORE If you have questions or need assistance, please call customer service at 855-944-3571.
Page 2
State of California to cause cancer and birth coverage, it is important to defects or other reproductive harm. To minimize register your Westinghouse exposure, wear gloves or wash your hands frequently when servicing this equipment. For more information go product.
IMPORTANT! WARNING! Always disengage the switch lever and remove the battery pack before making any adjustments, Safety Instructions inspecting, servicing, changing accessories, cleaning the snow blower, or when any other dangerous conditions are present. All Operators Must Read These Any such operation should be performed after revolving parts inside the snow blower stop completely.
TOOL ONLY - BATTERY AND CHARGER SOLD SEPARATELY Battery & Charger with a damaged cord or plug. Replace a damaged charger immediately. Safety Instructions • Do not use an extension cord unless it is absolutely necessary – Using the wrong, damaged or improperly wired We pay a great deal of attention to the design of every battery extension cord poses a risk of fire and electric shock.
Page 5
If the battery or charger are damaged, safety reasons. If this situation happens, stop the tool and please contact Westinghouse Outdoor Power Equipment let the battery cool down for a few minutes before restarting. (855) 944-3571.
Westinghouse Outdoor Power Equipment (855) 944-3571. • Noise control – When using the snow blower, respect the local laws and regulations regarding noise control and environmental protection.
Electrical Safety • When work is completed – Remove the battery pack from the snow blower when not in use, when changing accessories, and before performing any maintenance task. • Avoid accidental starting – Make sure the safety switch and the ON/OFF trigger is in the OFF position before inserting the •...
Safety Symbols The following table depicts and describes safety symbols that may appear on this product. Read, understand and follow all instructions on the machine before attempting to assemble and operate. Symbols Descriptions Symbols Descriptions READ THE OPERATOR'S MANUAL(S) – Read, understand WARNING! Do not expose the unit and follow all instructions in the to rain or wet conditions.
Know Your Cordless Snow Blower Read the owner’s manual and safety rules carefully before operating your cordless snow blower. Compare the illustration below to the actual unit in order to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.
2. Inspect the product carefully to make sure no breakage or damage occurred during shipping. If you find damaged or missing parts, DO NOT return the unit to the store. Please call Westinghouse Outdoor Power Equipment (855) 944-3571. NOTE: Do not discard the shipping carton and packaging material until you are ready to use the cordless snow blower.
Page 11
Assembly Discharge Chute Assembly 1. Loosen the chute deflector knob to lift the chute deflector Assembling the frames (Fig. 8). 1. Secure the connection of the middle frame to lower frame Chute by fastening the first set of knobs and bolts on each side Fig.
Page 12
Remove the other hitch pin from the lower chute crank (Fig. Fig. 11 15). Fig. 15 Clips Hitch pin Middle frame Chute clean-out tool Lower chute crank Chute Crank Assembly 1. Remove the hitch pin from the female end of the lower chute crank (Fig.
Align the screw holes and secure with hitch pin (Fig. 18). 2. While depressing the safety switch button, pull the ON/OFF trigger toward you. Once the machine powers on, release the safety switch button and begin operation Fig. 18 (Fig. 21). The machine can only be started by depressing the safety switch button first, followed by squeezing the ON/ OFF trigger;...
Rotate the chute control crank To order genuine replacement parts or accessories call clockwise to move the discharge chute to the left and Westinghouse Outdoor Power Equipment (855) 944-3571. counterclockwise to move the chute to the right (Fig. 22). WARNING! Make sure to turn off the switch and remove Fig.
Should you need to repair or 2. Install only new batteries of the same type in your product replace a part, contact Westinghouse Outdoor Power (where applicable). Equipment (855) 944-3571 for assistance. 3. Failure to insert batteries in the correct polarity, as indicated 3.
Service + Support If your cordless snow blower requires service or maintenance, please call the Westinghouse Outdoor Power Equipment (855) 944-3571. Model + Serial Numbers When contacting the company, reordering parts or arranging service from an authorized dealer, you will need to provide the model and serial numbers, which can be found on the decal located on the housing of the unit.
Need help?
Do you have a question about the WSnow22T and is the answer not in the manual?
Questions and answers