ADLINK Technology CEI-2x10G SFP+ User Manual

Network adapter card for express-vr7

Advertisement

Quick Links

CEI-2x10G SFP+ Network Adapter
CEI-2x10G SFP+
Network Adapter Card for Express-VR7
Page 1
Revision:
0.1
Date:
2023-12-18
Part Number:
50M-79029-1000
Copyright © 2023 ADLINK Technology, Inc.
User's Guide
PICMG COM.0 R3.1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CEI-2x10G SFP+ and is the answer not in the manual?

Questions and answers

Summary of Contents for ADLINK Technology CEI-2x10G SFP+

  • Page 1 CEI-2x10G SFP+ Network Adapter PICMG COM.0 R3.1 CEI-2x10G SFP+ User’s Guide Network Adapter Card for Express-VR7 Revision: Date: 2023-12-18 Part Number: 50M-79029-1000 Page 1 Copyright © 2023 ADLINK Technology, Inc.
  • Page 2: Revision History

    CEI-2x10G SFP+ Network Adapter PICMG COM.0 R3.1 Revision History Revision Description Date Author Preliminary release 2023-12-18 Page 2 Copyright © 2023 ADLINK Technology, Inc.
  • Page 3: Preface

    Product names mentioned herein are used for identification purposes only and may be trademarks / registered trademarks of respective companies. Copyright © 2023 ADLINK Technology Incorporated This document contains proprietary information protected by copyright. All rights are reserved. No part of this manual may be reproduced by any mechanical, electronic, or other means in any form without prior written permission of the manufacturer.
  • Page 4 Only install/attach and operate equipment on stable surfaces and/or recommended mountings; • If the equipment will not be used for long periods of time, turn off the power source and unplug the equipment. • Page 4 Copyright © 2023 ADLINK Technology, Inc.
  • Page 5 Caution: This information indicates the possibility of minor physical injury, component damage, data loss, and/or program corruption. Warning: This information warns of possible serious physical injury, component damage, data loss, and/or program corruption. Page 5 Copyright © 2023 ADLINK Technology, Inc.
  • Page 6 ADLINK Technology GmbH Hans-Thoma-Strasse 11, D-68163 Mannheim, Germany Tel: +49-621-43214-0 Fax: +49-621 43214-30 Email: emea@adlinktech.com Please visit the Contact page at www.adlinktech.com for information on how to contact the ADLINK regional office nearest you. Page 6 Copyright © 2023 ADLINK Technology, Inc.
  • Page 7: Table Of Contents

    4. Pinout and Signal Descriptions ......................................................14 4.1. Input Interface Definitions ............................................................14 5. Module Interfaces and Configuration ..................................................... 17 5.1. Connector and LED Locations ..........................................................17 5.2. Network Adaptor Card Installation ........................................................18 6. Mechanical ..............................................................19 Page 7 Copyright © 2023 ADLINK Technology, Inc.
  • Page 8: List Of Figures

    Figure 1 – CEI-2x10G SFP+ function diagram ..................................................13 Figure 2 – Adapter card feature locations .................................................... 17 Figure 3 – Adapter card installation illustration ................................................. 18 Figure 4 – CEI-2x10G SFP+ mechanical dimensions ................................................ 19 Page 8 Copyright © 2023 ADLINK Technology, Inc.
  • Page 9: Introduction

    Utilizing the CEI-2x10G SFP+ card along with an Express-VR7 COM Express module and Express-BASE7 Plus reference carrier board, you can easily emulate the functionality of your end product for software development and hardware verification. Applications include entry level switch, cloud storage platforms, communications servers, and more. Page 9 Copyright © 2023 ADLINK Technology, Inc.
  • Page 10: Specifications

    Up to 2x 10G SFP+ interfaces via 2x SFP+ connectors 2.2. 10GbE PHY Intel CS4227 Converts 10GBASE-KR and sidebands to 10G SFP+ interface PHY Firmware on SPI ROM Dedicated ROM for storing PHY firmware Page 10 Copyright © 2023 ADLINK Technology, Inc.
  • Page 11: Dimensions

    CEI-2x10G SFP+ Network Adapter PICMG COM.0 R3.1 2.3. Dimensions 168 mm x 107 mm (PCB only, including edge connector) 2.4. Operating Temperature 0°C to 85°C Page 11 Copyright © 2023 ADLINK Technology, Inc.
  • Page 12: Specification Compliance

    I2C based device, de-serialized for low speed sideband I/O, including interrupt, reset, etc. PCA9545 Multiplexer I2C based device, identifies the capabilities of the attached site. PCA9685 LED Ctrl I2C based device, controls LED indication Page 12 Copyright © 2023 ADLINK Technology, Inc.
  • Page 13: Block Diagram

    CS4227 ETH_PHY_INT# I2C[0:1] (2 ports) CEI_I2C (SDA/SCL) PCA9545 TX_Disable, TX_Fault, RX_Loss, ModPresN... CEI_RST# PCA9555 IO Expander CEI_INT# PCA9685 Link Status, Link Speeds LED Ctrl Indicators Figure 1 – CEI-2x10G SFP+ function diagram Page 13 Copyright © 2023 ADLINK Technology, Inc.
  • Page 14: Pinout And Signal Descriptions

    PICMG COM.0 R3.1 specification. Signals described in the specification but not supported on the CEI-2x10G SFP+ card are marked with strikethrough STRIKETHROUGH. Row B Row A Name Name CEI_SDA CEI_SCL 3V3SB 3V3SB 5VSB 5VSB Page 14 Copyright © 2023 ADLINK Technology, Inc.
  • Page 15 CEI-2x10G SFP+ Network Adapter PICMG COM.0 R3.1 Row B Row A Name Name ETH_PHY_INT# CEI_INT# CEI_RST# 10G_KR_RX1+ 10G_KR_RX1- 10G_KR_TX1+ 10G_KR_TX1- CEI_MDIO CEI_MDC 10G_KR_RX0+ 10G_KR_RX0- 10G_KR_TX0+ 10G_KR_TX0- Page 15 Copyright © 2023 ADLINK Technology, Inc.
  • Page 16 CEI-2x10G SFP+ Network Adapter PICMG COM.0 R3.1 Row B Row A Name Name Page 16 Copyright © 2023 ADLINK Technology, Inc.
  • Page 17: Module Interfaces And Configuration

    5. Module Interfaces and Configuration This chapter describes connectors, LEDs, and switches that are used on the CEI-2x10G SFP+ card. 5.1. Connector and LED Locations Figure 2 – Adapter card feature locations Page 17 Copyright © 2023 ADLINK Technology, Inc.
  • Page 18: Network Adaptor Card Installation

    Below is an example (illustration purposes only) of the CEI-2x10G SFP+ card installed on an Express-BASE7 Plus carrier board with a Type 7 COM Ex- press module. Figure 3 – Adapter card installation illustration Page 18 Copyright © 2023 ADLINK Technology, Inc.
  • Page 19: Mechanical

    CEI-2x10G SFP+ Network Adapter PICMG COM.0 R3.1 6. Mechanical Figure 4 – CEI-2x10G SFP+ mechanical dimensions Note: All dimensions are shown in millimeters with a tolerance of ± 0.25mm unless otherwise noted. Page 19 Copyright © 2023 ADLINK Technology, Inc.

Table of Contents