Subscribe to Our Youtube Channel
Related Manuals for Manamed PlasmaWave
Summary of Contents for Manamed PlasmaWave
- Page 1 PlasmaWave ® INSTRUCTIONS FOR USE Vascular Therapy System (Compressible Limb Sleeve Device) ©2024 ManaMed LLC. All rights reserved. ManaMed, the ManaMed logo, are trademarks of ManaMed LLC Registered in the U.S. Recovery activated. TD-PWAVE01-IFU Rev A...
-
Page 2: User Maintenance
USER MAINTENANCE PURPOSE OF DEVICE The purpose of the PlasmaWave is to aid in the prevention of Deep Contains no serviceable parts. Contact ManaMed Customer Service at 888-508-0712. Inspect the unit and all components for any damage that may have occurred... -
Page 3: Quick Start
Hook & Loop to hold it in place. Make sure the wrap is snug, but not too tight. OR: Instead of the using the Plasmawave cuff, shown below is the blue M-31 reusable sleeve, which should be used with the Go INSTRUCTIONS Green M-32 disposable barrier sleeve. -
Page 4: Warnings And Precautions
WARNINGS WARNING: . The use of the wrong Contact ManaMed Customer Service at 888-508-0712 for any questions or to request a replacement. Do not attempt to repair the device. Do not attempt to open or remove covers. Do not remove the pump unit from the cuff. Do not attempt to modify or change the device. -
Page 5: Electromagnetic Compatibility (Emc)
GUIDANCE AND MANUFACTURER’S DECLARATION - ELECTROMAGNETIC EMISSIONS The PlasmaWave is intended for use in the electromagnetic environment specified below. The customer or the user of the PlasmaWave should assure that it is used in such an environment. Emissions Tests Compliance Electromagnetic Environment Guidance The PlasmaWave uses RF energy only for its internal function. - Page 6 TV broadcast cannot be predicted theoretically with accuracy. To assess the electromagnetic environment due to the fixed RF transmitters, an electromagnetic site survey should be considered. If the measured field strength in the location in which the PlasmaWave is used exceeds the applicable RF compliance level above, the PlasmaWave should be observed to verify normal operation.
Need help?
Do you have a question about the PlasmaWave and is the answer not in the manual?
Questions and answers