Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for RunCam Thumb 2
Summary of Contents for RunCam Thumb 2
- Page 1 Camera Manual...
-
Page 2: Lens Cover
Overview Lens cover Ventilation Holes Micro SD Card Slot 1.25mm 3P Ventilation Button (5V/GND/PWM) Holes (power/shutter button) Type-C Indicator Light (Red/Green) Lens Cover Step 1 Align the lens cover to the mounting holes Step 2 Rotate the lens cover to the left to lock it. Step 3 Finished... - Page 3 Camera Mounting Micro SD Card MicroSD U3 card is recommended (4K@60FPS/4K@30FPS/ 2.7K@60FPS/1080P@120FPS requires U3 or above) Capacity of card is supported up to 512GB and above. Notice: Use carefully when handling memory cards. Avoid liquids, dust, and debris. As a precaution, please power off the camera before inserting or removing the card.
-
Page 4: Basic Operations
1. Applying succeeds, light turns to solid red Configuration Mode 2. Applying fails, light stays solid green Remote Control Mode Connect Thumb 2 to a PWM pad of FC to configure Micro SD Card Error Red light flashes quickly Sensor Module Error... -
Page 5: Configuration Setting
Configuration Setting Go to RunCam App to select Thumb 2 Configure the setting and generate a QR code Power on the camera, double press the button to switch to scanning mode, light turns to solid green Use camera to scan the QR code... -
Page 6: Remote Control
Speedy Bee F7 V3, with Power wire to 5V pad, GND wire to GND pad, Tx wire to R3 pad and Rx wire to T3 pad. Use BetaFlight to configure, setting the UART3 of SpeedyBee F7 V3 as RunCam device. - Page 7 CH5 to SE position. Test Power on Thumb 2 and the Flight Controller ·Set the SE to the bottom, the camera starts/stops recording PWM Remote Control Here we take Flight Controller Speedy Bee-F7 for an example Solder the JST 1.25*3pin wires to the...
- Page 8 Configure M6 at CLI mode ·Connect the flight controller to BetaFlight and enter the CLI interface ·Type in resource to proceed, and type the command as below # resource motor 6 none # resource pinio 2 B05 # set pinio_config = 129,129,1,1 # set pinio_box = 0,41,255,255 # save Test method one (recommended)
-
Page 9: App Download
SF position moves quickly from middle to bottom and goes back to middle, generating an effective command. App Download Please search “RunCam” in Google Play or Apple Store to download, or download the App on the official page. Download Product Support Product Support Notice: camera will shut down when its temperature reaches 96℃. -
Page 10: Microsd Card
Micro SD Card Mode Runcam Thumb 2 Sensor IMX586 (4800MP) 4K: 3840x2160@30/30(4�3)/60(xv)/60fps, 2.7K: 2688x1512@60(4�3)/60fps, Resolution 1440p：1920x1440@60fps, 1080p：1920x1080@60/60(xv)/120fps Video Format Gyro Bulit-in Communication Interface Type-C Micro SD Card Capacity Max 512G Power Input DV 5V(Only) Remote Control PWM/UART Power Consumption Max 700mA@5V Dimension 26mm*27.5mm*55mm...
Need help?
Do you have a question about the Thumb 2 and is the answer not in the manual?
Questions and answers