Advertisement
Removing and Fitting Cutting Line - Height Adjustment
• The cutting line is sharp, wear gloves and take
care when handling it. Check the cutting line
frequently during use and on completion of
trimming.
Removing the Cutting Line
Fitting the Cutting Line
(K)
•
•
Only use Green coloured cutting line on the
Turbo Trim XL400.
If you do not intend to use your trimmer for long periods
it is advisable to follow this procedure after use:-
(F).
Cleaning
Keep your trimmer clean grass clippings left in
any of the air intakes, around the engine or under
the deck could become a potential fire hazard. Do
not clean with chemicals, including petrol, or
solvents - some can destroy critical plastic parts.
See 'Height adjustment',
Carrying your Trimmer
Never carry a trimmer when it is running
Storing Your Trimmer
Air Filter Cleaning Instructions number 1)
If engine is operating in dusty or dirty areas the
air filter system will require shorter maintenance
intervals.
Cooling system air-intake
•
Never operate the engine without the debris
guard and foam filter being fitted, failure to fit
the debris guard and foam filter will cause
premature engine failure.
ENGLISH - 3
(J)
Fig. L
Caring for your Trimmer
(S)
Cleaning the Air Filter
(see
Cooling system debris guard
Changing the height of cut
Three heights of cut ONLY
N. Heighest height of cut
R. Lowest height of cut
(M1)
(M1)
(M4)
•
Important:- Cutting line must be on the side of
the disc facing the grass when fitted.
(M6)
(M4)
(M2)
At the end of the Trimming Season.
Switch off the engine, wait until the cutting disc
has stopped and disconnect the spark plug lead
BEFORE attempting any maintenance or
adjustment.
Do not re-connect the spark plug lead.
Air Filter Cleaning Instruction
(T3)
(T2)
(T3)
(V5)
(M2)
(M5)
(M6)
(N, P, & R)
(M5)
(M3)
(M1)
(M1)
'Cleaning the Air Filter'.
See 'Cleaning'.
Service Centre/Dealer
(T1)
(T2)
(T1)
(T1)
(T5)
(V2)
(V3)
(V6)
(V4)
(M3)
(T4)
(V1)
Advertisement
