Page 1
Countertop Nugget Ice Cube Maker Instruction Manual THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND SAVE IT FOR FUTURE REFERENCE.
CONTENTS Important Safety Instructions Preparing Your Ice Maker for Use Getting to Know Your Unit Operating Procedures & Maintenance Using Your Ice Maker Troubleshooting Technical Parameters Circuit Diagram...
IMPORTANT SAFETY INSTRUCTIONS Your safety and the safety of others are very important. We have provided many important safety messages manual and your appli- ance. This is the safety alert symbol: Always read and obey all safety messages. All safety messages will follow the safety alert symbol and the word “DANGER” or “WARNING”.
Page 4
PREPARING YOUR ICE MAKER FOR USE We do not recommend the use of an extension cord, as it may overheat and become a risk of fire. If you must use an extension cord, use No.14AWG minimum size and rated no less than 1875 watts. Unplug the ice maker before cleaning or making any repairs or servicing.
Page 5
PREPARING YOUR ICE MAKER FOR USE IMPORTANT: The wires in this mains lead are colored in accordance with the following code: [Green] or [Green with a strip yellow] Grounding [White] Neutral [Black] Live To avoid a hazard due to instability of the appliance, it must be placed at a even or flat surface.
GETTING TO KNOW YOUR UNIT Float switch Secondary water reservoir: It connects directly with the evaporator Water reservoir Maximum water level Filter A. Ice-making and cleaning buttons B. Ring indicator light Control Panel C. Water lack indicator light D. Ice full indicator light Top cover, removable from the top Hot Air outlet Ice basket...
OPERATING PROCEDURES & MAINTENANCE Remove the exterior and interior packaging, and then check all the acces- sories are included. If any parts are missing, please contact our customer service. Remove all the tapes on the unit; take out the accessory parts inside. Clean the interior with lukewarm water and a soft cloth.
Page 8
OPERATING PROCEDURES & MAINTENANCE DANGER *Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is damaged, please call our customer service. This unit should be properly grounded for your safety. The power cord of this appliance is equipped with a grounding plug that mates with standard grounding wall outlets to minimize the possibility of electric shock.
USING YOUR ICE MAKER How to start the unit Take out the ice basket, and pour potable water into the water reservoir, 0.3-gallon water at most at one time. Put back the ice basket. pour water 3. Plug in and the ring indicator will red light on. If you press the "ice /clean" button, the machine will start making ice;...
Page 10
USING YOUR ICE MAKER Secondary water Top cover reservoir Water reservoir Ice basket Water drain cap Tips: remove the top back cover by pulling up the front clear cover gently. Change water in the water reservoir every 24 hours to ensure a reasonable hygiene level.
Page 11
USING YOUR ICE MAKER System Cleaning/Sanitizing Procedure 1. Unplug the nugget ice maker. 2. Take off the bottom drain cap and drain out the water to a sink. See the figure below. 3. Produce a solution by diluting one teaspoon of household bleach with five cups of water for daily cleaning.
Page 12
USING YOUR ICE MAKER 4. Pour the solution into the water reservoir, up to the “MAX” water level.See the figure below. 5. Plug in the Nugget ice maker,press and hold the "Clean" button for 5 seconds to initiate the cleaning process(15mins).See the figure below. 6.
Page 13
USING YOUR ICE MAKER Repeat the step 4 to 6 with fresh water for two more cycles to rinse the inside. Replace the drain cap on the bottom. See the figure below. 9. When completed, fill the unit with fresh water and press the "Ice" button to start ice making process.
Page 14
USING YOUR ICE MAKER How to obtain the ice-cube Before we start making ice, please make sure the water drain cap has been inserted into the appliance; otherwise, it will not work properly. Press the “ICE/CLEAN” button, Ring indicator light flashes white, and it begins to work, Press this button again, and it will stop making ice.
TROUBLESHOOTING POSSIBLE CAUSE SOLUTION PROBLEM Lack of Water. Stop the ice maker, fill water, “Add Water ” and press “ICE/CLEAN” button indicator turns again to restart the unit. There is too much ice. Suggest you take out the ice-cube. “ICE FULL” indicator turns No ice cube inside.
TECHNINCAL PARAMETERS Model VH1211 Protection Type Power 115V/60Hz Ice Making Current 2.7A Refrigerant R600a / 16g Vesicant 287x220x322 mm Dimension (11.3x8.7x12.7 inch) CIRCUIT DIAGRAM ELECTRICAL DIAGRAM Overload Protector POWER Start Relay COMPRESSOR DC Fan Motor PUMP Pump For Water WATER LEVEL...
Page 17
To continuously improve its products, VIVOHOME reserves the right to modify this information without prior notification. For any questions regarding assembly, please watch the video on the product page or contact our customer service. Our customer service will gladly assist you with any additional questions, comments, or concerns.
Need help?
Do you have a question about the VH1211 and is the answer not in the manual?
Questions and answers