Care And Maintenance; Cleaning The Unit; Cleaning The Air Filter - Danby DPAC10010 Owner's Use And Care Manual

CLEANING
THE UNIT
CAUTION: Before cleaning or servicing this unit,
disconnect from any electrical supply outlet.
1) DO NOT use gasoline, benzene, thinner, or any
other chemicals to clean this unit, as these
substances may cause damage to the finish and
deformation of plastic parts.
2) Never attempt to clean the unit by pouring water
directly over any of the surface areas, as this will
cause deterioration of electrical components and
CLEANING THE
CAUTION: Never operate this unit without the air filter in place, as this may result in
AIR FILTER
damage to the unit.
If the air filter becomes clogged with dust/dirt, air flow is restricted, which reduces
cooling efficiency. The air filter should be cleaned every two (2) weeks. More
frequent cleaning may be necessary depending on indoor air quality.
NOTE: The air filter is located at the upper rear side of the unit.
1) To remove the air filter: Pull the air filter cover upward in the direction of the
arrow (Fig. 4) and remove the air filter.
2) Dust/dirt clogged in the filter can be removed by vacuum cleaning the soiled
areas.
3) The filter can also be washed in lukewarm, soapy water while rubbing it lightly
with a brush. A mild detergent (diswashing liquid) is recommended.
4) Rinse the filter well using clean water. Allow time to dry before reinstalling
into the unit.
5) Replace the air filter and cover.
6) Replacement air filter information is available by contacting the Customer Service
Department at:
1-800-26-

CARE AND MAINTENANCE

3) Unplug the unit.
4) Clean the unit by wiping off any dirt/dust with a
CAUTION: Always store the unit in vertical
position. DO NOT put heavy objects on top of the
unit.
(1-800-263-2629).
8
wiring insulation.
soft damp cloth or vacuum cleaner, then wipe dry
with a dry soft cloth.
Fig. 4