2. How to Install 1. Install any software required to operate your USB device. Note: Please refer to your USB device's manual for installation instructions. 2. Connect the AC Power Adapter to the TU2-NU4 and then to a power outlet. 3.
3. Configure the TU2-NU4 1. Insert the Utility CD-ROM into your computer's CD-ROM Drive. 2. Click Run autorun.exe (Windows Vista only). 3. Click Install Utility. 4. Follow the InstallShield Wizard instructions and then click Finish. 5. Click Yes, I want to restart my computer now and then click Finish.
Page 6
For detailed information regarding the TU2-NU4 configuration and advanced settings, please refer to the Troubleshooting section, User's Guide on the Utility CD-ROM, or TRENDnet's website at http://www.trendnet.com. Register Your Product To ensure the highest level of customer service and support, please take a moment to www.trendnet.com/register...
4. Using the TU2-NU4 1. Connect your USB device to one of the 4 USB ports on the TU2-NU4. 2. Verify that the LED for the USB port is lit. 3. In the utility, select your USB device and then click connect.
2. Power cycle the TU2-NU4 to force all USB devices to be disconnected. If you still encounter problems or have any questions regarding the TU2-NU4, please refer to the User's Guide included on the Utility CD-ROM or contact TRENDnet's Technical Support Department.
Page 9
Certifications This equipment has been tested and found to comply with FCC and CE Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received. Including interference that may cause undesired operation.
Need help?
Do you have a question about the TU2-NU4 and is the answer not in the manual?
Questions and answers