Page 2
Table of Contents Table of Contents English ...................... 1. Before You Start ................. 2. How to Install ..................Troubleshooting ..................Version 03.21.2008...
1. Before You Start Package Contents TU-IDES SATA cable Power Y cable Quick Installation Guide System Requirements CPU: 300MHz or above / 800MHz or above for Windows Vista Memory: 256MB RAM or above / 512MB RAM or above for Windows Vista IDE device (e.g.
Page 4
2. How to Install 1. Shutdown your computer. Then open up your computer. 2. Connect your IDE device to the TU-IDES. 3. Connect the provided SATA cable to the SATA receptacle on the TU-IDES. 4. Connect the female Berg power connector on the provided power Y-cable to the TU-IDES.
Page 5
8. Boot up your computer. Your installation is now complete. Register Your Product To ensure the highest level of customer service and support, please take a moment to www.trendnet.com/register register your product Online at: Thank you for choosing TRENDnet English...
Page 6
Fourth, connect the TU-IDES to a different IDE power connector on your computer. Fifth, connect a different IDE device to the TU-IDES. If you still encounter problems or have any questions regarding the TU-IDES, please contact TRENDnet's Technical Support Department.
Page 7
Certifications This equipment has been tested and found to comply with FCC and CE Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received. Including interference that may cause undesired operation.
Need help?
Do you have a question about the TU-IDES and is the answer not in the manual?
Questions and answers