Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for BenQ PointWrite PRJ PW02
Summary of Contents for BenQ PointWrite PRJ PW02
- Page 1 PointWrite Calibration guide Partie Yeh DJA1 BenQ HQ 2013/2/15...
-
Page 2: Installation
Installation Mounting Fix PW01 module to the bottom case of the projector with a screw which could be found in PW01 kit packing list. Connecting Plug in with USB cable and connect to PC. The LED indicator on PW01 show red means the it has already been power and operated. - Page 3 Calibration(1/3) STEP1. install PointWrite and Qwrite STEP2. active PointWrite and start for calibration process Seeing the pop up message means PW01 is under operating click right key on the mouse and select “configuration” Select short throw and your mounting position. Note : It’s named Upointer and I pro for vender test...
- Page 4 Calibration(2/3) Click alignment Important ! Make sure the pattern is totally covered in black area. pattern Black area...
- Page 5 Calibration(3/3) Select auto calibration and Select manual calibration wait below pop up then for 16 point via PW01 pen the calibration finish. click to points of the wall. Perform more accurate on the Auto calibration speed to corner. be around 1~3sec depends on PC CPU perform.
-
Page 6: Problem Shooting
Problem shooting Calibration fail 1. If your meet calibration fail problem, try to turn down the brightness in the room. 2. Check again your projection screen is under the affective capture area . WXGA model will be more risky to fact this problem compare to XGA models.
Need help?
Do you have a question about the PointWrite PRJ PW02 and is the answer not in the manual?
Questions and answers