Related Manuals for Petwant PWS 102
Summary of Contents for Petwant PWS 102
- Page 2 Petwant PWS 102 Keep the water level high. Top up the water frequently When the fountain runs dry, the pump burns out. Clean your fountain every 2 or 4 Clean the pump and weeks with soap. After cleaning, the fountain make sure that there is no soap stuck to the fountain.
- Page 4 Setting the fountain Install the filters and pump Wash the activated carbon filter to prevent excess activated carbon dust. Assemble the pump bracket, assemble the activated carbon filter. Place the foam filter so that the foam surrounds the pump.
- Page 5 Install the fountain cover Route the cable through the tunnel and Insert the pump into the foam filter and place both on the square in the out of the bowl base. bottom of the bowl. Push down.
- Page 6 Install the rubber sealing cap Place the silicone cap and fold its Place the tower on the filter body top edge down over the top edge and press down on the silicone gasket through the tunnel. This will keep the cable in place and prevent water from to seal.
- Page 7 1. Remove the pump cover 2. Use your fingernail to remove the impeller cover by placing it under the small lip where the impeller is located. 3. Remove the impeller and clean its parts using soap and warm water. Notice 1. Please remember to turn off and disconnect the power for safety reasons when the device is not in use.
- Page 8 The device has been approved for use in EU countries and is therefore provided with the CE mark. All necessary documentation is available on the website: www.elektro- obojky.cz Changes to technical parameters, properties and printing errors reserved. Service center and distribution Reedog, sro Sedmidomky 459/8 101 00 Prague 10...
Need help?
Do you have a question about the PWS 102 and is the answer not in the manual?
Questions and answers