Installation Guide PCAM-CHMSL-RAM CHMSL Camera for RAM Trucks Prior to Installation Cover all surfaces with tape or plastic protection film to protect against scratching and damage. EchoMaster is in no way responsible for any damage that may incur during installation.
Installation Guide PCAM-CHMSL-RAM CHMSL Camera for RAM Trucks Vehicle Preparation & Protection CAUTION Consult your vehicle owner’s manual to disconnect the battery. Do not disconnect ANY airbag connectors or indicators. Doing so may result in activating a diagnostic code. These codes will require the dealer to perform the reset procedure which may incur a reset fee.
Page 4
Installation Guide PCAM-CHMSL-RAM CHMSL Camera for RAM Trucks Installing CHMSL Camera Step 1 Remove the 2 x Philips screws that secure third brake light Step 2 Grab the light at the bottom and pull up and out, then disconnect the white connector on the back.
Page 5
Installation Guide PCAM-CHMSL-RAM CHMSL Camera for RAM Trucks Step 5 Install the top cap on the camera housing and fasten with 2 x Philips screws provided. Step 6 Inside the truck, remove the dome light from the headliner. Step 7...
Page 6
Installation Guide PCAM-CHMSL-RAM CHMSL Camera for RAM Trucks Step 9 Remove 1 x Philips screw from the top of the C pillar panel and pull to release top clip. Remove the rubber door moulding from the headliner to the floor.
Installation Guide PCAM-CHMSL-RAM CHMSL Camera for RAM Trucks Wiring Diagram Power 12V Ground Video email - support@aampglobal.com (US) - tel - 800-477-2267 Illustrations are typical and may not match exact vehicle details.
Page 8
If you do not agree, please discontinue use immediately and contact EchoMaster. This product is intended for off-road use and passenger use only. Clearwater Florida 33760 EchoMaster is a Power Brand of AAMP Global. IG-PCAM-CHMSL-RAM www.echomaster.com REV. 180919 email - support@aampglobal.com - tel- 866-766-2267 (US)
Need help?
Do you have a question about the PCAM-CHMSL-RAM and is the answer not in the manual?
Questions and answers