StorageWorks SW800 Installation Manual

This guide describes the layout and configuration of
SW800 storage data center cabinets with the fan tray
assembly installed. These procedures are applicable to
SW800 storage data center cabinets in which any of the
following are installed:
•
StorageWorks controllers
•
StorageWorks shelves
•
StorageWorks tape drives
____________ WARNING ____________
Remove ac power from cabinet components
prior to working in the cabinet interior.
Failure to do so may result in personnel injury
as a result of electric shock.
___________________________________
Prior to performing any procedure in this guide, remove ac
power from cabinet components. If the cabinet is in
operation, spin down all disk drives and halt all tape drives
in the cabinet. Switch the circuit on the front panel of each
CDU to the O (OFF) position.
Installation Preparation
The fan tray assembly in these cabinets provides additional
cooling for 7200 rpm disk drives.
Prior to installing the fan tray assembly, please check the
fan tray assembly kit for all required parts (see Table 1 and
Figure 1).
Table 1 Fan Tray Assembly Installation Kit
Part List
Assembly, Fan Tray, 115V 60Hz (SW8XF-AA) or
Assembly, Fan Tray, 230V 50Hz (SW8XF-AB)
Assembly, Fan Tray Shroud
Screw, SEMS 10–32
Nut, U–Nut 10–32
™StorageWorks is a trademark of Digital Equipment Corporation.
©Digital Equipment Corporation 1995
Printed in the U.S.A.
All Rights Reserved.
Solutions
Figure 1 Fan Tray Assembly
FAN TRAY
ASSEMBLY
GROMMET
Cabinet Preparation
If there is no shelf mounted in storage position S7, proceed
to the Fan Tray Assembly Installation. If there is a shelf
mounted in storage positon S7, proceed as follows:
1. Disconnect the power cable from S7.
2. Remove the two stop brackets.
3. Remove the shelf from storage position S7.
4. Remove the shelf mounting brackets and hardware
5. You may either store the removed shelf and brackets,
Qty
1
1
4
4
SW800 Fan Tray
Installation Guide
LEFT
RAIL
CABLE
CLAMP
POWER
SHROUD
SCREW
10-32 PAN
(4X)
CABINET REAR
from storage position S7.
or if available, install them in another storage positon
location using the removed hardware (refer to your
Cabinet Configuration for the proper loading
sequence).
RIGHT
RAIL
U-NUT
10-32
(4X)
CXO-4579A-MC
EK–SW500–A1.A01
February 1995