Table of contents 1. Read first: Safety information 1. Read first: Safety information ......3 Always read and follow the safety information accompanied by this symbol. 2. Important information ........7 3. Package contents ..........8 • Always test the system according to the instructions before use and always test the product after adjustments 4.
• Only use recommended power supply as stated in the • Only use the charging device and cord that is designated Technical Data section. for the product. • The power supply can be used as a disconnecting device. • Do not charge or use the device if you notice any The wall socket shall be installed near the equipment and malfunction or potential problem with the battery as shall be easily accessible.
Eliza S+ can transmit alarms over broadband/ the Eliza S/S+. network connections and mobile phone networks. Eliza S can The person receiving the alarm can then speak directly with transmit alarms over mobile phone networks.
1. I/O connector 3.5 mm audio out or wired input 2. Ethernet port Connection for Ethernet cable from broadband/network (Eliza S+ only) 3. External antenna For an external antenna that must be adapted for use with 2G/3G/4G connector 1. Loudspeaker 5.
5.3. Indicator lights & symbols 6. Installation 6.1. Remove top cover ALARM Steady light Normal operation CAUTION Blinking light Alarm activated Only authorised persons may open the cover. Turn GREEN off the device and disconnect the external power supply before removing the cover. Steady light Mains power Blinking light...
6.2. Inside view 6.3. Install the SIM card Illustration below is shown with the top cover removed. IMPORTANT Turn off the device and disconnect the external power supply before removing the cabinet. • Carefully move the battery aside to expose the SIM card holder.
2. Depending on selected transmission path: a. Connection via mobile network (GSM/UMTS/LTE) (Eliza S/S+). b. Fixed network connection (only Eliza S+). 3. Data connection via mobile network (GSM/UMTS/LTE). 4. Voice connection via mobile network (GSM/UMTS/LTE). 5. Data connection to a digital Alarm Receiving Centre (ARC).
8. Programming 9. Verification Contacts, alarm codes and settings are programmed via Always check the function after installation and pairing. the device management system i-care® online Test alarms shall be done regularly and in a way that www.icareonline.com or with a computer via a web secures the whole alarm chain from radio transmitter to browser.
9.2.1. On device check 10. Radio trigger Check the mobile network signal strength on the device. The radio trigger uses two-way radio communication, this 1. Press and hold the button with Yellow circle means that when Eliza S/S+ receives an alarm from a radio trigger the carephone will send a confirmation of receipt to 2.
Backup battery: 3.7 V, 2000 mAh, Li-Ion data and requirements of the new user. Backup time: Eliza S: Up to 168 hours 12.3. Battery management Eliza S+: Up to 72 hours (new and fully charged Effective battery management is essential for the reliability battery) of telecare devices.
The product can be returned free of charge to a recycling station that is connected, directly or via a recycling system, to Careium or to your distributor. For detailed instructions, declarations and compliance information please check with your distributor or visit our website, www.careium.com.
Nothing herein should be construed as constituting an Average active efficiency 86,64 % additional warranty. Efficiency at low load (10 %) 84,12 % Careium shall not be liable for technical or editorial errors or omissions contained herein. No-load power consumption 0,057 W...
Need help?
Do you have a question about the Eliza S and is the answer not in the manual?
Questions and answers