Denon AVR-791 Owner's Manual page 57

ENGLISH
Manual Setup
Setting items
Channel Level Test Tone Start : Output test tone.
Set the volume of the test • FL / C / FR / SR / SBR
tone to be the same when it speaker.
is output from each speaker. z When the "Speaker Config." – "S.Back" setting (vpage 53) is set to
"1sp", "S.Back" is displayed.
• –12.0dB – +12.0dB (0.0dB) : Adjust the volume.
• When
"Subwoofer" setting switches to "OFF".
• When "Channel Level" is adjusted, the adjusted values are set for all the
surround modes. To adjust the channel level separately for the different
surround modes, use the operation see page 35.
NOTE
• Speakers set to "None" in the "Speaker Config." (vpage 52) settings
are not displayed.
• When a headphones jack is inserted in the PHONES jack of this unit, the
"Channel Level" is not displayed.
Default : The "Channel Level" settings are returned to the default settings.
• No : Do not reset to the defaults.
• Yes : Reset to the defaults.
Crossover Frequency Crossover : Set the crossover frequency.
Set the maximum frequency • 40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz /
of the bass signal output
250Hz
from each channel to
Advanced : Specify crossover frequency for each speaker.
the subwoofer. Set the
• Front / Center / Surround / S.Back / Front Height : Select the speaker.
Crossover Frequency to
• 40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz /
suit the bass reproduction
250Hz : Set the crossover frequency.
capability of the speaker
being used.
• "Crossover Frequency" can be set when the "Bass Setting" –
"Subwoofer Mode" (vpage 53) setting is "LFE+Main", or when you
have a speaker that is set to "Small".
• Always set the crossover frequency to "80Hz". When using small
speakers, however, we recommend setting the crossover frequency to
a higher frequency.
• For speakers set to "Small", sound below the crossover frequency
is cut from the sound output. The cut bass sound is output from the
subwoofer or front speakers.
• The speakers that can be set when "Advanced" is selected differ
according to the "Subwoofer Mode" setting (vpage 53).
• When "LFE" is selected, speakers set to "Small" at "Speaker Config."
can be set. If the speakers are set to "Large", "Full Band" is displayed
and the setting cannot be made.
• If set to "LFE+Main", this setting can be made regardless of the
speaker size.
54
Remote control operation
buttons
Setting details
z / SBL z / SL / FHL / FHR / SW : Select the
o is pressed while the subwoofer volume is set to "–12 dB", the
Move the cursor
(Up/Down/Left/Right)
Setting items
Front Speaker Setup DIRECT/STEREO : The front speakers used in the direct, stereo and pure
Set the front speakers to direct play modes (2 channel) are set in advance.
use for every surround • A：Front speaker A is used.
mode. • B：Front speaker B is used.
• A+B：Both front speakers A and B are used.
NOTE
MULTI CH : The front speakers used in modes other than the direct,
This can be set when "Amp
stereo and pure direct play modes (2 channel) are set in advance.
Assign" is set to "Front B"
• A：Front speaker A is used.
(vpage 52).
• B：Front speaker B is used.
• A+B：Both front speakers A and B are used.
Confirm the setting
Setting details
Return to previous menu