Page 5
ENGLISH Make sure the mounting device or Never leave the mounting device mobile holder is not installed where inside the car in direct sunlight or in you might come in contact with it in excessive heat. The mounting device the event of an accident or collision. and suction cup may be damaged and adhesion may be impaired if the inside Periodically check that the suction cup...
Page 6
ENGLISH and clean the surface thoroughly with mounting device clockwise (1D) to a glass cleaner and a clean towel. If create a vacuum between the suction the ambient temperature is below cup and the windscreen. Check that +15°C (60°F), carefully warm the the mounting device is firmly surface and the suction cup with a attached (1E).
Page 7
ENGLISH Attach the holder to the protective sheet from the pad, do not touch the adhesive side. mounting device Press the suction cup of the mounting To attach the mobile holder to the device against the pad (2B). mounting device, insert the catch on the mounting device into the slot at Turn the catch on the mounting device the back of the holder (2E).
ENGLISH plug to the charger connector on your device out from the holder. Pull the device. latch to its initial position, and slide the switch to the right, to lock the To remove the device, slide the switch latch in place. to the left, lift the latch, and pull the Taking care of your device Your device is a product of superior...
Need help?
Do you have a question about the CR-120 and is the answer not in the manual?
Questions and answers