LuxenHome WHAP2102 Instruction Manual

Product Name: 7.5Ft Pre-lit Green Slender Artificial Christmas Tree with Pine Cones
SKU #: WHAP2102
Thank you for purchasing this LuxenHöme product. This product has been manufactured with the highest
standards of safety and quality.
PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
Unpack all parts from inside the carton to ensure there are no missing or damaged parts. If any parts are missing
or damaged, do not attempt to assemble or use the product.
CARTON CONTENTS:
Description Quantity
Tree top (Section C) 1
Medium Tree (Section B) 1
Bottom Tree (Section A) 1
Metal folding stand 1
Before You Start
1. Decide on an appropriate location for your product, please read assembly and Instruction procedure carefully.
Note: These trees are for indoor use only.
2. Retain the instructions for future use and save the carton for storing your tree.
Assembly and Instruction Procedure (no tools required for assembly):
Step 1: Locate the tree stand or pot. If your tree has a metal stand, unfold it and insert the eye bolt. Remove
packing material from ends of poles. Put bottom section pole into tree stand making sure it is seated properly
(Fig. 1). Tighten eye bolt.
Step 2: Locate the bottom tree section "A" that is labeled with letter "A". Remove any protective pole caps from
ends of the pole (they can be saved and reused for storage). Put bottom tree section "A" into tree stand or pot.
Make sure the pole is seated properly. If your stand has eye bolts, then tighten eye bolt until bottom section is
held securely. Insert the top tree section into the green plastic opening of the lower tree assembly. There may be a
"pole cap" which keeps tree top section securely in place (Fig. 3). For larger tree with middle section, carefully
insert middle section pole(s) into bottom section pole (Fig.4). Then insert top section into pole cap. If you have
three (3) tree sections, then "A" is bottom section, "B" is middle section, "C" is top section. Note: Each tree section
is tagged with a letter, and "A" is always the bottom section that goes in tree stand, then B, C, D, etc.
CAUTION: Two people may be needed to balance and assemble the tree's upper sections. Please use a ladder if
needed, and follow the ladder's safety instructions.
Step 3: HINGED TREES: Branches should fall into place during assembly. If any branches remain upright, gently
lower them into proper position (Fig. 5). Each branch must be shaped to a natural position by spreading out the
Instruction Manual
Please save this manual for future reference.
Commented [SC1]: Bottom or top?
Commented [A2R1]: Bottom is A, top is C
Commented [SC3]: Conflicting info description
Commented [A4R3]: I revised the description already.