Hardware Installation - D-Link DNS-G120 Manual

DNS-G120 User's Manual

Hardware Installation

It is required that an Ether It is required that an Ethernet cable is used during initial setup. Once your It is required that an Ethernet cable is used during initial setup. Once your
wireless configuration is set, you may disconnect the Ethernet cable and wireless configuration is set, you may disconnect the Ethernet cable and eless configuration is set, you may disconnect the Ethernet cable and
reboot the DNS-G120 to connect to your wireless network. reboot the DNS-G120 to connect to your wireless ne reboot the DNS-G120 to connect to your wireless network.
1
Attach the provided Ethernet cable to the Ethernet port on the rear panel.
2
Attach the other end of the Ethernet cable to an available Ethernet port on
your router or switch.
3
Plug the AC adapter into the receptor located on the back of the device. Plug
the other end of the AC Adapter into a power strip or wall outlet.
4
Attach your USB drive(s) to the USB port(s) on the rear panel of the DNS-G120.
The USB LED on the front panel will blink until the drive has been installed.
Once the USB LED is solid green, your USB drive is ready for use.
D-Link Systems, Inc.
Hardware Installation
9