D-Link DNS-120 Install Manual page 6

Hardware Installation
1
Attach the provided Ethernet cable to the Ethernet port on the rear panel.
2
Attach the other end of the Ethernet cable to an available Ethernet port on
your router or switch.
3
Plug the AC adapter into the receptor located on the back of the DNS-120.
Plug the other end of the AC Adapter into a power strip or wall outlet.
4
Attach your USB drive(s) to the USB port(s) located on the rear panel of
the DNS-120. The USB LED on the front panel will blink until the drive has
been installed. Once the USB LED is solid green, your USB drive is ready
for use.
6
DNS-120 Install Guide
D-Link Systems, Inc.