Camera Monitor System Contents Page 1. System 1.1 System ON/OFF signal 1.2. Ambient light sensor 2. System Failure 2.1. Visual Alert 2.2. Sound Alert 2.3 Possible Failure System 3. Maintenance Camera Unit Monitor 12,3 " and 7" 4. Change log...
1. System 1.1. System ON/OFF signal The eMirror system will display the image in less than 7 seconds once the System ON/OFF signal goes from 0V to 12V/24V. The eMirror system will stop displaying the image after a few minutes depending on the vehicle configuration.
Camera Monitor System 2.2. Sound Alert At the same time that a light signal appears, the system will audibly indicate the existence of an anomaly in the system that must be attended to by the driver and corrected by the technical support service (see figure 2.3).
Camera Monitor System 3. Maintenance 3.1. Camera Unit Use water and neutral soap to wash the camera. Do not clean with aggressive or abrasive cleaning agents. 3.2. Monitor 12,3 " and 7" Turn off the device prior cleaning. Use a damp cloth or non-abrasive wipe to avoid scratching the screen.
Need help?
Do you have a question about the eMirror and is the answer not in the manual?
Questions and answers