Lcd; Knobs & Dials; Knobs; The Rotary Dial - Clavia Nord Wave User Manual

8 |
Nord Wave User Manual v1.1

lcd

the lcd is normally
used for displaying
the current program
bank, number, name
and category.
When operating a knob or button, the associated param-
eter name and setting will be displayed in the lcd.
Knobs & dials

Knobs

the knobs controls the
continuously variable param-
eters in the Nord Wave synth
engine.
a parameter value can be totally different from the
•
knob's physical position when you load a Program. as
soon as you start turning the knob, the value will 'snap'
to the knob's physical position.
Most of the knobs have a green LEd indicator below them.
this LEd is used for indicating when a parameter is con-
nected to a morPh source. Please refer to page 13 for
more information on morphing.

The rotAry dial

the rotAry dial is used for changing
the current setting displayed in the
lcd. Usually this means loading a new
program, but in the System or MIdI
menus, the rotAry is used to change
parameter settings.
led-dials
these dials in the oscillator section
have an associated led diSPlAy which
shows their parameter setting. they are
used to select wavetables or Sample
Instruments.

mASter level knob

the mASter level knob controls
the overall amplitude for the audio
outputs, the line level outputs and
headphone output. the mASter level
knob's actual position indicates the
output level.

Buttons

Selector buttons
Selector buttons are used to activate one setting in an
array of two or more. Selector buttons have a set of round
or triangular LEds to indicate the current setting. Press the
button several times to cycle through the possible options.

On/Off buttons

on/off buttons are used for activating
a parameter or a group of parameters
such as effects.
Shift button
Some buttons have a secondary func-
tion, which will be available if you hold
down Shift while pressing the button.
the name of the secondary function is
printed below the button.