Important Safety Instructions - TeleAdapt ChargePort Pro Installation Manual

Important Safety Instructions

• Read these instructions carefully before attempting any installation.
Follow all instructions and heed all warnings. These instructions
should be kept for future reference.
• This equipment is designed for indoor use only.
• The mains plug used to disconnect this equipment from its power
source must be readily accessible at all times.
• Ensure the power cords are uncoiled before installation.
• Protect the power cords from being walked on or pinched
particularly at plugs, convenience receptacles and the point where
they exit from the equipment.
• The power cord must be plugged into a mains socket outlet with
protective earthing.
• The maximum distance to the receptacle (mains outlet) is
determined by the length of cord provided.
• Clean only with a dry cloth.
• Servicing is required when the equipment has been damaged in
any way. Refer all servicing to qualified service personnel.
• Unplug this equipment during lightning storms or when unused for
long periods of time.
• The wireless charger may get a little warm during use, this is
normal.
• The wireless charger will not charge any devices that do not
conform to the Qi specification.
• Do NOT defeat the safety purpose of the grounded plug. If the
provided plug does not fit into your outlet consult a qualified
electrician to replace the obsolete outlet.
• Do NOT install or use this equipment near water.
• Do NOT expose this apparatus to rain or moisture.
• Do NOT expose to dripping or splashing. No objects filled with
liquid such as vases shall be placed on the equipment.
• Do NOT install near any heat sources such as radiators, convection
heaters or other apparatus such as amplifiers that produce heat.
• Do NOT install in locations exposed to extended direct sunlight.
• Do NOT exceed the maximum load of 10 amps.
• Do NOT use the wireless charger with devices that are not Qi
Certified.
• Do NOT use corrosive, abrasive or solvent based cleaners on the
product.
• Do NOT attempt to disassemble this product, it may result in short-
circuit or even damage.
4
EN