TPI PB 36-B Instructions

It is important that the following safety precautions be followed when using this products:
• ALWAYS unplug unit for cleaning or maintenance.
• ALWAYS unplug unit when not in use.
• ALWAYS unplug unit when moving unit from one location to the next.
• ALWAYS plug fan into a properly rated electrical outlet.
• DO NOT place foreign objects through guards into blades.
• DO NOT allow the unit to become wet or damp.
• DO NOT over tension fan belt.
WARNING: To avoid risk of fire or electrical shock, DO NOT use this fan with any solid state speed
control.
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING: Do not use replacement parts that have not been recommended by the
manufacturer (e.g. parts made at home using a 3D printer).
OPERATING INSTRUCTIONS
This unit is equipped with an off/on switch, which allow you to select a desired amount of air delivery. TPI
Air Circulators can be used alone or in conjunction with an air conditioner to circulate and force cooled air
into other areas. During normal operation it is not uncommon for the motor to be warm to the touch. The
motor is equipped with a thermo-protector will automatically de-energize the fan if it were to over heat for
any reason. If this should happen immediately disconnect unit from the power outlet. If an extension cord
is required use only a 14/3 wire gauge minimum for lengths of up to 50 feet and 12/3 wire gauge for lengths
over 50 feet.
CLEANING/MAINTENANCE INSTRUCTIONS
All maintenance should be done by either TPI Corporation or a qualified electrician. The motor bearings
are lubricated at the factory and should not require any additional lubrication. However, if bearing lubrication
is required, apply a small amount of a high temperature bearing grease.
Use a 5/16" nut driver to loosen screws for removing front and rear fan guards. Use an air hose or vacuum
to remove any air born contaminates which may have settled on motor or bearings. Use mild detergent to
clean blade and guards. Avoid allowing the cleanser to come in contact with the motor bearings or windings.
Replace guards using 5/16" nut driver. Allow fan to completely dry before next use.
Reference parts list on reverse side of this instruction sheet. Save these important instructions. Your TPI
Air Circulator carries a one year warranty.
For additional information on TPI Products or replacement parts, call TPI Customer Service Department at
1-800-251-0382 or write to the address below.
P.O. Box 4973 * Johnson City, Tennessee 37602-4973 * 423-477-4131 * Fax 423-477-0683
Industrial Air Circulator Instructions
For All Non-Swivel Style Portable Belt Drive Blowers
READ AND SAVE THESE IMPORTANT INSTRUCTIONS
P/N: 9901
ECO 1-8027