ASUS will only be responsible for or indemnify you for loss, damages or claims based in contract, tort or infringement under this Warranty Statement. This limit also applies to ASUS’ suppliers and its reseller. It is the maximum for which ASUS, its suppliers, and your reseller are collectively responsible.
1. Safety Precautions FOR PRODUCTS CONTAINING LASER: DANGER- Invisible laser radiation when open. AVOID DIRECT EXPOSURE TO BEAM. CAUTION- Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. CAUTION- The use of optical instruments with this product will increase eye hazard. TO ENSURE THE CONTINUED RELIABILITY OF THIS PRODUCT, USE ONLY ORIGINAL MANUFACTURER'S REPLACEMENT PARTS, WHICH ARE LISTED WITH THEIR PART NUMBERS IN THE PARTS LIST SECTION OF THIS SERVICE MANUAL...
3. Disassembly and Assembly Procedures 3.1 Disassembly SOP Preparation before disassemble 1. Clean the room for disassemble 2. Identify the area for monitor 3. Check the position that the monitors be placed and the quantity of the monitor; prepare the area for material flow;...
Page 7
2. Unlock 4 screws from Back Cover. Screw: Torsion (SCRW MACH FLAT M4*8L of Stand ZN NYL) screw: 9.0±1.0 Kg-cm 3. Disassemble stand from Back Cover. 4. Unlock 1 Back Cover screw Screw: Torsion (#SCRW TP-P PH W/FL of Back M3*8 B-ZN) Cover screw:...
1. Disassemble Mylar from Main Shielding. 2. Unlock 6 PCBA screws. Screw: MAIN POWER (#SCRW M PH INT/TOO BOARD BOARD M3*9L ZN) LVDS cable 3. Disassemble the Main Board from Shielding. Speaker cable To power board 4. Pull out LVDS cable/ Audio cable/ Speaker cable/ Power Board cable from Torsion...
Page 9
1. Disassemble the Key Board from Middle Frame. 2. Unlock 9 Middle Frame screws. Torsion of Screw: Middle #SCRW MACH FLAT M3*5L NI Frame screw: 4.5±1.0Kg- 3. Tear off 2 tapes from Panel.
3.2 Assembly SOP Preparation before assemble 1. Clean the room for work 2. Identify the area for material 3. Prepare the implement, equipment and materials as bellow: 1) Working table 2) Screw-driver 3) Glove 4) Cleaning cloth 5) ESD protection After unplugging the power cord, the power Board still have power energe.
Page 11
Torsion 9. Lock 6 PCBA screws of PCBA Screw: screw: (#SCRW M PH INT/TOO 7.0± M3*9L ZN) MAIN 1.0Kg- POWER BOARD BOARD 1. Paste 2 tape on Panel 2. Assemble the Mylar in Main Shielding. Screw- driver 3. Insert the Light line into Panel.
Page 12
1. Insert the LVDS cable to Panel. 2. Paste the LVDS cable to MAIN Panel. BOARD 3. Assemble the Shielding on Panel. 4. Paste 2 tape conduct on Panel. 5. Paste the light line on Panel by black tape. 6. Paste the LVDS cable to Panel.
Page 13
11. Assemble Hinge cover to Back Cover. 12. Finish.
Need help?
Do you have a question about the VA24DQF and is the answer not in the manual?
Questions and answers