Table of Contents
Advertisement
Refer to your battery's label for battery type. Contact your local
recycling centre for proper disposal methods.
Warning: Never dispose of batteries in a fire because they may
explode.
Installing the Battery
Your phone is designed to use only Motorol aOriginal
batteries and accessories.
Note: Your phone is shipped with a protective clear
plastic liner covering the battery door latch. Remove the
liner to ensure that the battery door attaches and closes properly.
1.
3.
18 - Getting Started
Turning Your Phone On
Action
1 Open your phone.
2 Press and hold the power key P
for 2 seconds to turn the phone
on.
Note: It may take up to 4 seconds
for the display to illuminate after
you turn the phone on.
3 If necessary, enter your SIM card PIN code and press
( + ) to unlock the SIM card.
Caution: If you enter an incorrect PIN code 3 times in a row,
your SIM card is disabled and your phone displays
4 If necessary, enter your 4-digit unlock code and press
( + ) to unlock the phone.
Turning Your Phone Off
Action
Press and hold the power key P for 2 seconds to turn the phone
off.
Adjusting Volume
Press the up or down volume keys to:
• silence an incoming call alert
• increase or decrease earpiece
volume during a call
20 - Getting Started
2.
Charging the Battery
New batteries are shipped partially charged. Before you can use
your phone, you need to install and charge the battery as described
below. Some batteries perform best after several full
charge/discharge cycles.
Action
1 Insert the travel charger
plug into your phone with
the release tab facing up.
Make sure that both of
the plug's connector
hooks engage to lock the
plug in place.
2 Plug the other end of the travel charger into the appropriate
electrical outlet.
Note: It make take up to 10 seconds for your phone to
provide a visible or audible indication that the battery is
charging.
3 When your phone indicates
tab and remove the travel charger.
Tip: You can safely leave the travel charger connected to the
phone after charging is complete. This will not damage the battery.
• increase or decrease the ringer volume setting when the home
screen is visible (flip must be open)
Tip: At the lowest volume setting, press the down volume key
once to switch to vibrate alert. Press it again to switch to silent
alert. Press the up volume key to switch back to vibrate alert,
then ring alert.
Making a Call
You must be in the home screen to dial a phone number (see
page 35).
Press
1 keypad keys
2 N
.
3 O
Tip: You can also close the phone flip to end the call.
Answering a Call
When you receive a call, your phone rings and/or vibrates and
displays an incoming call message.
When the phone flip is active, open the phone to answer the call.
(To activate, press M >
>
To
dial the phone number
make the call
end the call and "hang up" the phone
when you are finished
>
.)
, press the release
Getting Started - 19
>
Getting Started - 21
Advertisement
Table of Contents
