HOMCOM EF942UK Manual page 3

21. When transporting or storing the heater keep in a dry place, free from excessive
vibration and store so as to avoid damage.
22. The flame effect is powered by a motor and it is normal for the motor to make
some noise as it slowly rotates and helps to create the beautiful 3D flame effect.
Some rooms have more or less furnishings than others resulting in varying noise
amplification.
23. Whilst every effort is made to ensure packing materials are kept outside of the
plastic bag which covers your heater in the box, there is a remote chance that some
packing may lodge itself in the heater part of the unit. If you notice this on close
inspection, please remove it. When turning your heater on for the first time it is
normal for the heater to emit a little 'new heater' smell which quickly passes.
24. You may notice some light coming from under or from the sides of the unit. This
is normal and the holes allow the unit to 'breathe'. Do not attempt to block these
holes.
25. WARNING: In order to avoid overheating, do not cover the heater.
26."CAUTION: TO PREVENT ELECTRIC SHOCK MATCH WIDE BLADE OF
PLUG TO WIDE SLOT, FULLY INSERT."
27. This heater is hot when in use. To avoid burns, do not let bare skin touch hot
surface. Keep combustible materials, such as furniture, pillows, bedding, papers,
clothes, and curtains at least 3 feet (0.9 m) from the front of the heater and keep
them away from the sides and rear.
28. Do not use this heater in wet or moist locations.
Installation
The fire must not be used until it is securely fastened to the wall.
Do not connect the appliance to the mains until properly fixed to the wall and the
instructions are read fully.
The minimum distances must be observed in the diagrams above.
For installation of the appliance, care must be taken not to damage concealed
cables.
Please be careful whilst drilling holes.
This appliance is designed to be permanently fixed to a wall at a minimum height of
300mm.The wall bracket must be fitted horizontally and the cable routed to the
bottom right of the heater.
A distance of 600mm from bottom of heater to floor is recommended for optimum
viewing of fuel bed; see Fig.1 for recommend fixing dimensions.
For optimum viewing, mark the top four screws fixing positions on wall in
accordance with the recommend fixing dimensions- see Fig.2.