GE Profile OPAL P4INAASSTSS Owner's Manual page 10

Care and Cleaning
System Descaling / Sanitizing Procedure
(continued)
6. Descaling
or use the Opal Cleaning Kit and follow the instructions
provided.
Sanitizing
and then adding one teaspoon of bleach.
7. Plug in Opal and hold the Clean button for 3 seconds to
NOTE: Water will begin circulating and the Cleaning
indicator will light up on the left-hand side of the unit to
confirm the unit is now in the cleaning process. After three
minutes, the water will stop, the Cleaning indicator light will
maker is not interacted with for 5 minutes, the pulsing will
state.
8. Descaling: run the clean cycle up to 3 times, with the
descaling solution, and then let the unit sit for 18 hours
and soak. While the unit is soaking, dip a cloth in the
solution and wipe the inner walls. Use a cotton swab to
clean any cracks. When you are done, rinse the cloth
with clean water and wipe Opal again to remove any
scale deposits.
Sanitizing: Once the Cleaning indicator turns off,
promptly drain the Opal.
pressing the Clean button to initiate a second cleaning
cycle. Once the cleaning cycle has completed, drain the
unit of all water.
reservoir each time (you may continue to repeat the rinse
mode at any time, press and hold the 'Clean' button for
three seconds.
Opal.
12. When complete, fill the reservoir with fresh water and press
10
water reservoir
Making Ice Add Water Clean Defrosting
Clean Power
Hold 3 Sec
Clean Power
Hold 3 Se
49-9000041 Rev. 2