Victorian Plumbing EcoDelux Fitting Instructions Manual

Wall hung pan

Advertisement

Wall Hung Pan
Fitting Instructions
Please follow them carefully and
leave this manual with end user
V2.08.24

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EcoDelux and is the answer not in the manual?

Questions and answers

Summary of Contents for Victorian Plumbing EcoDelux

  • Page 1 Wall Hung Pan Fitting Instructions Please follow them carefully and leave this manual with end user V2.08.24...
  • Page 2: Items Included

    Before you begin: We recommend that this product is installed by a qualified tradesperson, Victorian Plumbing Ltd. accept no liability for products incorrectly installed, or where the correct testing procedures have not been adhered to, thus resulting in the escape of water and consequential damage.
  • Page 3 Preparing for a Wall Hung Toilet Pan fitting: • Please note: This guide advises on the installation of the wall hung toilet pan only. Flush Pipe is supplied with the concealed cistern assembly, (Wall Frame/Cistern sold separately) Pan connector (waste pipe) supplied with Wall Frame/Cistern assembly. •...
  • Page 4 Wall Hung Toilet Pan Fitting: After the wall frame has been set in the wall and the wall has been finished, proceed to install the toilet pan to the wall. Step 1: • Prepare the pipes as advised (cutting of the flush pipe and pan connector may be required).
  • Page 5 Step 3: • Insert the ‘Wall Mounting Brackets’ into the holes at the rear of the toilet pan and align the hole with the fixing hole of the toilet pan. Secure the brackets in place by tightening the back of the fixing bracket using the ‘Plastic Widget’ provided. Step 4: Please Note: It is recommended that two people should carry out this section.
  • Page 6: Troubleshooting

    Step 5: • Once assembly is completed, turn on the water supply, check for leaks and check the flush operation. • Pipe a fine bead of good quality silicone sealant around the back of the toilet pan, wipe away any excess silicone with a damp cloth and allow 24 hrs to fully dry. •...
  • Page 7: Maintenance

    Maintenance All of the maintenance measures resulting from troubleshooting above requires you to access the internals of the cistern tank and for the water supply to be turned off. Please refer to the instruction guide supplied with your cistern for further guidance. Cleaning To maintain the surface finish of your product, wipe the toilet regularly using a clean damp cloth, a mild detergent mixture can be used.
  • Page 8 www.victorianplumbing.co.uk V2.08.24...

Table of Contents