Advertisement
READ AND UNDERSTAND ALL SAFETY INFORMATION BEFORE USING THIS PRODUCT. Failure
to
follow these safety instructions may result in ELECTRICAL SHOCK, EXPLOSION, FIRE, which may
result in a SERIOUS INJURY, DEATH, or PROPERTY
DAMAGE.
Electrical Shock.
Product is an electrical device that can shock and cause serious injury. Do not cut power
cords. Do not submerge in water or get wet.
Explosion.
Unmonitored, incompatible, or damaged batteries can explode if used with product. Do not
leave product unattended while in use. Do not attempt to jump start a damaged or frozen battery. Use
product only with batteries of recommended voltage. Operate product in well ventilated areas.
Fire.
Product is an electrical device that emits heat and is capable of causing bums. Do not cover product.
Do not smoke or use any source of electrical spark or fire when operating product. Keep product away from
combustible materials.
Eye
Injury. Wear eye protection when operating product. Batteries can explode and cause flying debris.
Battery acid can cause eye and skin irritation. In the case of contamination of eyes or skin, flush affected
area with running clean water and contact poison control immediately.
Explosive Gases.
Working in the vicinity of a lead-acid is dangerous. Batteries generate explosive gases
during normal battery operation. To reduce risk of battery explosion, follow all safety information instructions
and those published by the battery manufacturer and manufacturer of any equipment intended to be used
in the vicinity of battery. Review cautionary markings on these products and on engine.
For more information
and support visit:
Advertisement
Table of Contents
Need help?
Do you have a question about the GENPRO Series and is the answer not in the manual?
Questions and answers
i have the 10X3, I was charging batteries through the winter. I checked today and the first indicator light is off. this goes to the cranking battery. Tested the battery and it was dead. how can the battery go dead while being charged. Thank You
The cranking battery likely went dead while using the NOCO Genius GENPRO Series 10X3 charger because the charger was not properly configured to charge the starting battery. The GENPRO Series chargers have different charging modes for various battery types, and if the starting battery was not receiving charge due to incorrect mode selection or wiring setup, it could discharge over time. Additionally, if the charger was primarily connected to the trolling batteries at the front and not properly extended or configured to maintain the starting battery at the back, it would not receive sufficient charge.
This answer is automatically generated
I have a bank that shows the lithium battery is charged, but when I pull it up on the battery app. it is not recharging the battery to 100% even thou the NOCO Gen 10 x 4 show green light to be at 100. All the other 3 banks work fine.