O2 Concepts Oxlife Independence Orientation Manual

O2 Concepts Oxlife Independence Orientation Manual

Advertisement

Quick Links

®
Oxlife Independence
Provider Orientation
Guide
®
O2-CONCEPTS.COM | 877-867-4008
800-1060 REV: A

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Oxlife Independence and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for O2 Concepts Oxlife Independence

  • Page 1 ® Oxlife Independence Provider Orientation Guide ® O2-CONCEPTS.COM | 877-867-4008 800-1060 REV: A...
  • Page 2: Feature Identification

    Introduction The Oxlife Independence is a portable oxygen concentrator used on a prescriptive basis ® by patients requiring supplemental oxygen in a home, office or institutional environment or in a vehicle/mobile environment. The device delivers 87%-95% pure oxygen to a patient through a standard single lumen nasal cannula.
  • Page 3: Device Settings

    Device Settings Continuous flow settings of 0.5 to 3.0 LPM. Pulse dose settings of 0.5 to 6.0 in the following volumes: External Power To use the AC power supply, connect the power cord to the AC power converter (brick). Then connect the power supply to the Independence and wall outlet.
  • Page 4: Installing/Removing Battery

    Installing/Removing Battery Hold the battery as shown with pull tab up and the battery connection to the bottom and install into the back of the device as shown. The battery will drop down slightly and click into position. Battery Operation Times Battery charge status is displayed on the control panel and on the battery.
  • Page 5: Device Monitoring

    If the device has not connected within 15 minutes, power the device off and remove all power sources (batteries, AC/DC power supply). After 30 seconds, reconnect the power supply and power the device on to repeat process. Device Monitoring Access O2 Concepts’ DNA portal at: www.o2dnaportal.com Enter user name and password. Page 4 of 6...
  • Page 6 Provider Screen Press and hold the Mode button and Down arrow button simultaneously to enter the provider screen. Device status and language setting can be accessed from this screen. Service Mode Screen Press and hold the Up and Down arrow buttons simultaneously to access the service mode screen. Device run hours can be accessed from this screen.
  • Page 7: Device Identification

    Battery power is depleted, device will shut down No Flow Flow of oxygen has stopped for 45 seconds Unauthorized Battery A non-O2 Concepts battery is detected, and no other power source is available Low External Power Voltage to the device is below 10.6 volts...
  • Page 8 ® O2-CONCEPTS.COM | 877-867-4008...

Table of Contents