GE WSKS2060W2WH Owner's Manual page 12

(con) PERFORMANCE
Pilling
Snags, holes, tears, rips
or excessive wear
Wrinkling
NOISE
Washer is noisy
OTHER
Labels on the exterior
of the washer will not
peel off cleanly
Possible Causes
Result of normal wear on
poly-cotton blends and
fuzzy fabrics
Pins, snaps, hooks, sharp
buttons, belt buckles,
zippers, and sharp objects
left in pockets
Undiluted chlorine bleach
Chemicals like hair bleach
or dye, permanent wave
solution
Improper sorting
Overloading or
incorrect water level
Incorrect wash and
dry cycles
Repeated washing in
water that is too hot
Possible Causes
Washer is uneven
Washer load is
unbalanced
Shipping foam is still assembled
in unit
Washer is sitting too close
to wall (causes knocking
during cycle)
Possible Causes
Occasionally the adhesive
used on the labels does
not release cleanly
What To Do
• While this is not caused by the washer, you can slow the
pilling process by washing garments inside out.
• Fasten snaps, hooks, buttons, and zippers.
• Remove loose items like pins, objects in pockets
and sharp buttons.
• Turn knits (which snag easily) inside out.
• Check bleach package instructions for proper amount.
• Never add undiluted bleach to wash or allow clothes
to come in contact with undiluted bleach.
• Rinse items that may have chemicals on them before
washing.
• Avoid mixing heavy items (like work clothes) with
light items (like blouses).
• Try a fabric softener.
• Load your washer so clothes have enough room
to move freely.
• Match Cycle selection to the type of fabric you are
washing (especially for easy care loads).
• Wash in warm or cold water.
What To Do
• To level the washer, adjust the leveling legs by rotating
the individual legs in the proper direction for up or down.
• Press the START/PAUSE button to stop the washer, open
the lid and redistribute the load evenly. Close the lid and
restart.
• Remove foam blocks from the bottom of the washer.
• Pull washer away from the wall; about 4" is needed.
What To Do
• Use a hair dryer set at the lowest heat setting, directing
the air at the label for a short amount of time. This will
release the adhesive easily, without damaging the surface
of the washer.
11