Table of Contents
Advertisement
C H A P T E R
Operating Your TV
Once you have connected your TV to an antenna or cable system, plugged the TV in,
and put batteries in the remote, you are ready to use the TV. The first thing you should
do is program your TV so it memorizes all of the available channels.
Turning Your TV On
1
Programming Your TV's Channel Memory
Your TV's memory determines the channels that are available using the
buttons. If a channel is not in memory, you can tune to it with the number buttons, but
not with the
1 With the TV on, press the MENU button.
2 Use the
3 Use the
select AIR or CABLE. If you connected an antenna to your TV, select AIR; if you
connected a cable system, select CABLE.
4 Use the
tons to begin the AUTO PROGRAM process. This process takes a few minutes.
5 Press the MENU button to return to normal TV viewing.
Your TV's channel memory will not be affected by a power outage. You will not need to
re-program the memory unless you change the type of cable antenna connected to your
TV.
1
10
Chapter 3 : Operating Your TV
3
1 To turn your TV on, press the POWER button on the remote
control. You can also use the POWER button on the front panel.
Make sure your TV is plugged in before you try to turn it on.
V
W
CH
buttons. Follow these steps to program your TV's memory:
V
W
CH
buttons to select SETUP and press
V
W
CH
buttons to select ANTENNA, then use the
V
W
CH
buttons to select AUTO PROGRAM, then use the
2
CVOLB
3
V
W
CH
.
CVOLB
buttons to
CVOLB
but-
4
Advertisement
Table of Contents
