Subscribe to Our Youtube Channel
Related Manuals for Biostar iDEQ C1
Summary of Contents for Biostar iDEQ C1
- Page 6 Hardware Installation...
- Page 16 JKBV1 JATXPWR1 JSFAN1 LGA775 JATXPWR2 JNFAN1 (optional) JCFAN1 IEEE 1394 Chip (optional) P4M800CE VT8237R VT8237R+ BAT1 JSATA1 JSATA2 JCMOS1 IDE1 Super JCDIN1 Codec IDE2 BIOS FDD1 JUSBV1 JUSB3 JPANEL1 JUSBV3 JMIC1 JOUT1 JUSB2 JUSB1 Note: ■ represents the 1 pin.
-
Page 17: Hardware Installation
Pull the lever sideways away from the socket and then raise the lever up to a 90-degree angle. Step 2: Look for the black cut edge on socket, and the white dot on CPU should point wards this black cut edge. The CPU will fit only in the correct orientation. -
Page 18: Fan Headers
Hold the CPU down firmly, and then close the lever to complete the installation. Step 4: Put the CPU Fan on the CPU and buckle it. Connect the CPU FAN power cable to the JCFAN1. This completes the installation. FAN HEADERS These fan headers support cooling-fans built in the computer. -
Page 19: Memory Module Installation
MEMORY MODULE INSTALLATION 1. Unlock a DIMM slot by pressing the retaining clips outward.Align a DIMM on the slot such that the notch on the DIMM matches the break on the Slot. 2. Insert the DIMM vertically and firmly into the slot unti l the retaining chip snap back... - Page 23 The JCFAN1 and JSFAN1 support 4-pin and 3-pin head connector. When connecting with wires onto connectors, please note that the red wire is the positive and should be connected to pin#2, and the black wire is Ground and should be connected to GND.
- Page 28 Power Source Header for 1394 Chip: J1394V1 +3.3V +3.3V SB JUSB3/JUSB4: HEADERS FOR USB 2.0 PORTS AT FRONT PANEL This header allows user to connect additional USB cable on the PC front panel, and also can be connected with internal USB devices, like USB card reader.
- Page 56 50-iDEQC1-M-E1...
Need help?
Do you have a question about the iDEQ C1 and is the answer not in the manual?
Questions and answers