Custom Side Panels - Dacor EF42DBSS Installation Instructions Manual

Custom Side Panels - IF42/IF48
Custom side panels may be needed when not enough space is
available to have cabinets on both sides of the refrigerator or
when the refrigerator is placed at the end of a cabinet run. You
may choose an Inset or Recessed Inset panel installation for
models IF42 and IF48.
Refrigerator and Side Trim Dimensions
The width and height of a side panel are determined by the type
of installation you are planning.
NOTES:
ƒ
The dimensions shown are actual product dimensions and
may not reflect the needed installation dimensions.
ƒ
The side panel should be a minimum of ½" (1.3 cm) thick to
avoid warping.
ƒ
If the opening depth is 25" (63.5 cm) or more, you may want to
install a support board on the rear wall.
Refrigerator
Side Trim
3/8" (9.7 mm)
1/16" (1.5 mm)
1/8" (3.2 mm)
12
Installation Requirements
23 1/2"
(59.7 cm)
3/16" (4.5 mm)
Inset Installation Dimensions
1. Measure the distance from point
wall. Add ¹⁄
" (0.8 mm) to this measurement to allow the side
32
panel to fit into the trim.
If the panel is more than ³⁄
2.
to allow the side panel to fit into the trim.
Back wall
A
A
Recessed Inset Installation Dimensions
1. Measure the distance from point
Route the front edge of the support board or attach a ³⁄
2.
mm) board to hold the panel in the cabinet side trim.
Back wall
A
B
A (as shown) to the back
" (9.5 mm) thick, rout the front edge
8
B (as shown) to back wall.
" (9.5
8