Hdmi Connection; Error Messages - Pioneer 575 - STEINER MARINE 7X50 Operating Instructions Manual

Additional information

HDMI connection

Problem
No HDMI audio output.
No HDMI video output.
Color problems occur
with your monitor after
changing the HDMI
Color setting (page 31).

Error Messages

Message
2CH ONLY
96K
SND.DEMO
NOISY
ERR MIC
ERR SP
MUTING
STEREO
TRAYLOCK
KEYLOCK
PHONESIN
Remedy
• See Switching the HDMI audio setting on page 36 to make sure that AUDIO ON
is selected.
• Make sure that you've selected this player as the HDMI input in the settings for
the component you're using (refer to the component's instruction manual).
• Check that the HDMI cable is connected properly and isn't damaged.
• Check that components connected using the HDMI interface are switched on
and HDMI compatible (components must be compatible with both DVI and High
Bandwidth Digital Content Protection (HDCP)).
• Depending on the component you have connected, using a DVI connection may
result in unreliable signal transfers.
• Make sure the resolution on this player matches that of the component you have
connected using HDMI. See Video Output settings on page 30 to change the HDMI
resolution.
• If the screen goes blank after changing the resolution, it means the you selected
a resolution incompatible with your monitor. See Resetting the HDMI connection
on page 36 to reset to the factory defaults.
• Depending on the connected equipment, some HDMI Color settings may cause
the picture to be displayed incorrectly. In this case, use the TV's own video input
settings to select RGB, if possible. Alternatively, revert to the previous HDMI Color
setting.
Description
• An operation is prohibited because it is only applicable to 2 channel sources,
while the current source is a multichannel source.
• An operation is prohibited because the source is 96 kHz digital.
• The sound demo is on. See General in Troubleshooting on page 44.
• Background noise is too high to complete MCACC setup successfully.
• An error occured during MCACC setup because the microphone is not
connected or is not connected properly.
• An error occured during MCACC setup because the speakers are not connected
or are not connected properly.
• An operation is prohibited because the sound is muted (press MUTE).
• An operation is prohibited because the tuner is selected.
• The tray lock is on. See General in Troubleshooting on page 44.
• The key lock is enabled. See Key lock setting on page 38.
• An operation is prohibited because the headphones are connected.
10
47
En