Sens SuperTorque 8Z Getting Started

Getting Started
Mounting
Battery Shelf or Battery Box
IMPORTANT!
THIS SIDE UP
520.7
20.5
245.6
9.7
Connections
Note - remove optional field cover
to access connections
Connect SENS SETUP UTILITY
using USB-C
Remove pluggable terminal block
to connect MODBUS RS-485
when optional display/comms PCA
included (28-16AWG, tighten to
2lb-in, pin 1: +D1 (A), pin 2: –D0
(B), pin 3: COM, pin 4: Shield)
M/N: 8Z-XX-X-XX-B-X-X-XX
M/N: 8Z-XX-X-XX-C-X-X-XX
To prevent battery discharge
when AC power is not connected,
press "SLEEP" button to turn off
display and communications
Connect J1939 network cable
to RJ-45 connector when
optional display PCA included
(pin 1: Data High, pin 2: Data
Low pin 8: COM)
M/N: 8Z-XX-X-XX-B-X-X-XX
Connect MODBUS TCP/IP
cable to RJ-45 connector when
optional comms PCA included
M/N: 8Z-XX-X-XX-C-X-X-XX
295.4
11.6
1/2 inch
conduit knockouts
for permanent
installation
wires
network
SENSBUS - connect load sharing
units or remote accessories
(DO NOT connect Ethernet, J1939,
TCP/IP OR RS-485 here)
USE YOUR SMART PHONE QR CODE READER TO
SuperTorque
Genset Starting System
THIS PRODUCT COVERED BY ONE OR MORE PATENTS: WWW.SENS-USA.COM/PATENTS
IMPORTANT!
THIS SIDE UP
245.6
9.7
Install using
3/8 inch
fasteners
Remove pluggable terminal block to connect
ALARM RELAY
(28-16AWG, tighten to 2lb-in, rated 30V AC/DC, 2A)
See unit label for factory alarm assignments, user
configurable with SENS Setup Utility
REFER TO THE USER MANUAL OR CONTACT SENS CUSTOMER SERVICE:
800-742-2326 / 303-678-7500 /
Rigid Floor Mount
520.7
20.5
348.9 152.4
13.7 6.0
73.8
2.9
Connect
wires using ring lugs and M8
fasteners (13mm socket wrench,
tighten to 60lb-in)
Optional - SAE battery terminal
posts
CAUTION:
present on battery terminals!
Press "WAKE UP"
display and communications on
when AC power is not connected
WARNING:
discharge, connect ac power as
soon as possible
Connect
(100-240VAC, 50/60Hz) using
18-14AWG IEC 320 power cord
≤20A UL Listed Branch Circuit
protection required, use UL
recognized wire rated ≥90C
Optional - wire AC to screw
terminal adapter provided with
field termination kit (18-14AWG,
tighten to 3.5lb-in)
Connect
unit) to load sharing units or
SENS-approved external devices
Form C contact wires
Need Help?
service@sens-usa.com
ACCESS USER MANUAL
8Z
TM
295.4
11.6
142.1
5.6
152.4
6.0
2X 0.4
4X .3X0.5
1/2 inch conduit
knockouts for
permanent installation
DC 1/0AWG minimum
voltage always
button to turn
this will cause battery
AC INPUT
AC OUTLET (4A per