Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for HeatStar 2HSHG5000C
Summary of Contents for HeatStar 2HSHG5000C
- Page 1 OWNER’S MANUAL CEILING MOUNT ELECTRIC HEATER 5,000W | 240V MODEL: 2HSHG5000C...
-
Page 2: Table Of Contents
SAFETY & PRECAUTIONS CONTENTS CONTINUED CONTINUED SAFETY INFORMATION ..............................3 SPECIFICATIONS ................................4 USAGE INSTRUCTIONS ..............................5 INSTALLATION INSTRUCTIONS ..........................6 SAFETY INSTRUCTIONS ............................... 7 CARE & MAINTENANCE ..............................7 HARDWIRED INSTALLATION REQUIRED This heater must be grounded and hardwired to a properly sized current protection circuit breaker in accordance with the (US) National Electric Code and local codes. -
Page 3: Safety Information
SAFETY INFORMATION INTENDED USE: 7. This heater is not suitable for use in hazardous locations as defined by the National Fire Electric Utility heaters are designed to meet a Protection Association (NFPA) in the United variety of heating requirements. This product States. - Page 4 Keep rear grille away from 2HSHG5000C HEAVY DUTY 5,000W ELECTRIC UTILITY HEATER WATTS SWITCH POSITION VOLTS (VAC)
- Page 5 MOUNTING INSTRUCTIONS WARNING MAXIMUM MOUNTING HEIGHT USING BRACKET FOR: FOR INDOOR USE ONLY, IN A DRY LOCATION FREE OF GASOLINE, HORIZONTAL / ANGLED AIR FLOW: PAINT, FLAMMABLE LIQUIDS The maximum recommended ceiling height OR COMBUSTIBLE DUST OR for effective vertical air flow is 8 ft. MATERIALS.
-
Page 6: Usage Instructions
USAGE INSTRUCTIONS Power and Temperature Power Control NOTE: Heater will cycle on and off to maintain Caution Indicators Controls Switch room temperature. The first time you operate the unit, it may smoke slightly. This is due to residual cleaning agents used to clean the element when the heater is manufactured. -
Page 7: Installation Instructions
INSTALLATION INSTRUCTIONS MOUNTING BRACKET INSTALLATION HANGING THE HEATER IN THE BRACKET Refer to Figure 4a and 4b. 1. Lift the heater into the mounting bracket and align the lower bracket holes with the threaded 1. Locate a ceiling joist or other firm structural holes nearest the heater’s center. - Page 8 INSTALLATION INSTRUCTIONS (Continued) CONNECTING THE POWER 3. Pull enough wire into the heater and connect to wire to the Power Block located in the 1. With the power off at the breaker, remove all electrical area of the heater, See Figure 7. screws from the bottom lid for access to the 4.
-
Page 9: Safety Instructions
1. The heater is HOT when in use. Do not let bare PURCHASING skin touch any hot surfaces. Accessories may be purchased at any HeatStar 2. Keep combustible materials (furniture, pillows, local dealer or direct from the factory. bedding, papers, clothes, curtains, and similar FOR INFORMATION REGARDING SERVICE items) at least 3 feet (0.9m) from all sides and... - Page 10 WARRANTY (Continued) has been repaired or altered outside of the factory in any respect which in our judgment affects its condition or operation. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.
- Page 12 ENERCO GROUP, INC. 4560 W. 160TH ST. CLEVELAND, OHIO 44135 866-447-2194 Heatstar is a registered trademarks of Enerco Group, Inc. © 2024, Heatstar. All rights reserved. Printed in China 0424_M009...
Need help?
Do you have a question about the 2HSHG5000C and is the answer not in the manual?
Questions and answers