Advertisement
Quick Links
Advertisement
Related Manuals for MAX PROP ELICA MAX PROP EASY
Summary of Contents for MAX PROP ELICA MAX PROP EASY
- Page 1 INSTRUCTION MANUAL ELICA MAX PROP EASY ® automatic feathering patented propeller...
- Page 2 5.How to pull the propeller off the propeller shaft PART TWO Possibilities offered by your MAX PROP EASY model ® A.The importance of propeller pitch B.How to change the pitch of the MAX PROP EASY model propeller ® C.How to establish the pitch variation...
- Page 3 PART ONE MAX PROP EASY MODEL PROPELLER ® INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS...
- Page 4 VITI BLOCCA-ZINCO LOCKING ZINC SCREWS 1. INTRODUCTION DADO - NUT ZINCO - ZINC Thank you for choosing a MAX PROP feathering propeller, EASY model. This ® instruction manual is used to answer your questions about installing and VITI BLOCCA-DADO operating the propeller. Before installing the propeller on the boat, it is essential...
- Page 5 3. CHECKS TO BE CARRIED OUT BEFORE LAUNCHING THE BOAT c. Insert the nut into its seat, screw it in and lock it by using the two locking a. Check that the propeller body rotates freely around the same shaft, so that nut screws that must be inserted in their seats and then tighten.
- Page 6 4. WARNINGS FOR THE USE AND MAINTENANCE OF THE PROPELLER a. The reverse gear must always be engaged starting from the forward gear • Start with a first hole of your choice position. Therefore, before engaging the reverse gear, the forward gear must •...
- Page 7 5. HOW TO PULL THE PROPELLER OFF THE PROPELLER SHAFT e. Fasten the puller (consisting of a perforated washer) to the zinc-holding ring by using special countersunk head screws. ESTRATTORE PULLER f. In each threaded hole of the zinc-holding ring, a countersunk head screw for ESTRATTORE locking the puller must be inserted.
- Page 8 PART TWO POSSIBILITIES OFFERED BY YOUR MAX PROP EASY MODEL ®...
- Page 9 20° 205 240 275 310 345 375 410 445 480 515 550 already set based on the requests and the data provided by the customer at the time of ordering. In any case, an innovative device patented by Max Prop offers, 22°...
- Page 10 B. HOW TO CHANGE THE PITCH OF THE MAX PROP EASY/WHISPER MODEL PROPELLER ® Two screws/rods are inserted in the body of MAX PROP EASY model propeller. ® A screw/rod is used to adjust the change in forward gear pitch. A screw/rod is...
- Page 11 (0.5°). Conversely, if the screw/rod, already inserted and set in its 2,5%. seat, is rotated counter-clockwise by an angle of 45°, the reverse gear pitch will The Max Prop propellers are supplied with two screws/rods each marked with ®...
- Page 12 4.4. Failure to comply with points 4.1, 4.2 and 4.3 shall result in the exclusion and 2. As soon as the goods are ready, Max Prop s.r.l. gives notice to the customer who must take voiding of the warranty.
- Page 13 NOTES...
- Page 14 090624...
- Page 15 MAX PROP ® viale Carlo Espinasse, 101 - 20156 Milano - ITALY tel. +39 02 33 404 325 - skype: maxprop1 www.maxprop.it - info@maxprop.it p.26...
Need help?
Do you have a question about the ELICA MAX PROP EASY and is the answer not in the manual?
Questions and answers