Page 1
ENERGY HARVESTING WIRELESS SENSOR INSTALLER Installation Instructions myenergi Ltd. Pioneer Business Park, Published April 2024 Faraday Way, Stallingborough, United Kingdom Grimsby, DN41 8FF, UK Revision B myenergi.com PM-00010...
Page 2
Copyright of these instructions remains Read all the safety instructions. Failure to with the manufacturer. Text and images cor- operate the harvi in accordance with these respond to the technical level at the time of instructions may cause injury, damage to the going to press.
Page 3
Ensure installed according to the instructions and that you return your used device to myenergi used in its intended environment. or obtain information regarding a local, This equipment generates, uses, and can authorised collection and disposal system.
Page 4
There is a cable grip installed on the back grid and/or generation power. Instead, the of the harvi. Simply pass the CT wire CT is connected to harvi. No power source is through the top hole and then push down needed for harvi - the energy harvested from to lock into place.
Page 5
If harvi is to be used on a 3-phase there is another device causing interference installation then ensure you set harvi on a particular channel.
Page 6
Category: conditions/myenergi-product-warranty/ ¹Minimum operating current may vary depending upon application of use. ²65A maximum rated current in measured circuit. harvi will measure higher currents to ensure any overload is correctly detected and managed in accordance with G100 requirements myenergi.com...
Page 8
Designed and manufactured in the UK by myenergi Ltd, Pioneer Business Park, Faraday way, Stallingborough, Grimsby, DN41 8FF T: +44 (0)333 300 1303 E: sales@myenergi.com W: myenergi.com myenergi.com...
Need help?
Do you have a question about the Harvi and is the answer not in the manual?
Questions and answers