Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Case Slot
Summary of Contents for Case Slot
- Page 1 Slot Shelving...
- Page 2 Con gurations The shelving system comes in four different assembly options as shown below, these are designed to suit a wide range of interiors. Width 900mm Width 600mm Single 900 system Single 600 system Width 900mm Width 600mm Extension 900 system Extension 600 system...
- Page 3 Illustrated below, outlines important design features that help with adapting the shelving system to suit your space. Please note: Wall bosses (A) and shelves (I) cannot be mounted in the same slot location on the upright (J). 25mm...
-
Page 4: Supplied Components
Mark here Upright Upright Upright 2 i. 2 ii. Mark here for Mark here for Line up Slot into 600 width unit 900 width unit Upright here K - Small L - Long Slot template Slot template Required Tools Screw... - Page 5 Slot into Upright 15th slot Mark here Slot into Upright Hook the three small templates (K) into the slot on the back of the upright (J), determining where your xing points go. 70th slot Mark here Slot into Upright Present the prepared upright (J) to the wall at the desired height, making sure the templates (K) are at to the wall.
- Page 6 It is very important that you are precise when marking the xing points onto your wall. Please follow these steps carefully. Mark the second upright xing points. Using the long slot In this example the template (L), align with First...
- Page 7 Assembly Important note: For wall plug compatibility refer to the of cial Fischer website. To list examples of suitable wall types; Concrete, Solid brick, solid sand-lime brick, plasterboard, chipboard, natural stone and more. Drill each of the marked xing points, ensure that you are using the correct drill bit for your wall.
- Page 8 Assembly Before attaching the wall boss (A) to the wall, x grub screw (C) to pinch the back end of pin (B), (section after intended groove). This temporarily secures the pin (B) in place with additional tolerance for attaching the uprights (J). Insert pin (B) into hole that intersects with threaded top hole for...
- Page 9 Fix assembled wall bosses (A) to the wall substrate. Slot upright (J) onto pin (B) attached to wall boss (A).
- Page 10 Loosen grub screw (C), allowing upright (J) to push closer to wall boss (A). Retighten grub screw (C) into place securing upright (J) rmly. Repeat this for the adjacent upright (J).
- Page 11 To attach the shelves (I), tilt the shelf (I) enough to t between the uprights (J) and then straighten the shelf (I) so that it is level.
- Page 12 Using the second person, look behind the xed uprights (J) to guide the shelf hooks into the slots.
- Page 13 Check each shelf (I) is level, using a spirit level. Once each shelf (I) is level, knock down connected corners to ensure slotted section is correctly in place.
-
Page 14: Care Instructions
Care Instructions Slot shelving – designed by Terence Woodgate The Slot wall adjustable shelving system is a pure minimal design where the components have clarity and are not compromised by visible slots or holes. By positioning the vertical supports slightly away from the wall, the shelves can be xed to hidden slots facing the wall.
Need help?
Do you have a question about the Slot and is the answer not in the manual?
Questions and answers