Table of Contents
Advertisement
Timer playback
Turns on the unit at a specified time for the specified duration.
Make sure the clock is set correctly.
1 Hold down SHIFT and press TIMER on the remote
control.
"5" lights up and "
PLAY" is displayed.
2 Within 12 seconds, press SET.
3 Press f or g to set the timer-on time, and
press SET.
Each press changes the time in 1-minute steps.
Holding these buttons down will vary the time in 10-minute
units.
4 Press f or g (TUNER/BAND, AUX or E
CD) to select the source, and press SET.
•For timer play of a CD, select "CD".
•For timer play of a radio broadcast, select "TUNER".
You will select the band later in step 7.
•For timer play of the equipment connected to the VIDEO/
AUX IN jacks, select "AUX (VIDEO or TV)".
5 Press f or g to set the timer-activated
duration, then press SET.
With each press, the timer-activated duration changes in
5-minute steps between 5 to 240 minutes.
6 Press f or g (turn VOLUME on the main
unit, or press VOLUME -,+ on the remote
control) to adjust the volume for timer playback,
and press SET.
The volume level can be adjusted from 0 to 24.
7 Prepare the source.
To play CD, load a disc.
To play the radio, select the band and tune in the desired
station.
To play external equipment connected to the VIDEO/AUX
IN jacks, set an external timer for the equipment so that
its playback begins at the same time.
8 Press POWER 6STANDBY/ON (POWER) to turn
the unit off.
"5" remains on the display to indicate the timer standby
mode (when ECO mode is deactivated).
At timer-on time, the unit turns on and plays the selected
source. After the specified timer-activated duration, the
unit turns off again.
•Timer playback will not begin unless the unit is turned off
first.
•Connected equipment cannot be turned on or off by the built-
in timer of this unit. Use an external timer.
To check the timer setting
Hold down SHIFT and press TIMER on the remote control so
that "
PLAY" appears on the display.
The timer-on time, the source and the timer-activated duration
are displayed for 12 seconds.
To change the timer setting
Reset the timer again.
To cancel the timer
Hold down SHIFT and press TIMER on the remote control
twice until "
OFF" is displayed. "5" disappears from the
display.
Tip:
Your timer setting is retained even if the timer is cancelled.
Next time the timer is activated, you can change your previous
setting, or simply use the same setting again.
En
13
Advertisement
Table of Contents
