Advertisement
Advertisement
Table of Contents
Related Manuals for Asus PA279CRV
Summary of Contents for Asus PA279CRV
- Page 1 Monitor Service Manual Model: PA279CRV Version no. v1 Release date: 2024/05/30...
- Page 2 Warranty Statement, up to the listed contract price of each product. ASUS will only be responsible for or indemnify you for loss, damages or claims based in contract, tort or infringement under this Warranty Statement.
- Page 3 Table of Contents Safety Precautions---------------------------------------------------------------------04 Exploded View--------------------------------------------------------------------------05 Disassembly and Assembly Procedures--------------------------------------------06 Troubleshooting------------------------------------------------------------------------11...
-
Page 4: Safety Precautions
1. Safety Precau ons Product Announcement: This product is certificated to meet RoHS Directive and Lead-Free produced definition. Using approved critical components only is recommended when the situation to replace defective parts. Vender assumes no liability express or implied, arising out of any unauthorized modification of design or replacing non-RoHS parts. -
Page 5: Exploded View
2. Exploded View Item Description Q'ty Item Description Q'ty FRONT BEZEL GASKET PANEL RISER POWER BOARD VESA MAIN BOARD BASE POWER BOARD MYLAR SCREW (M2 x L3.3) MAIN BRACKET SCREW (M2 x L5) LENS MYLAR SCREW (M3 x L7.5) FK BOARD SCREW (M4 x L11) POWER BOARD RUBBER SCREW (M4 x L8) -
Page 6: Disassembly And Assembly Procedures
3. Disassembly and Assembly Procedures 3.1 Disassembly SOP Put the rear cover on a protective cushion. Tear off Use a Philips-head screwdriver to remove four PVC tape and release the speakers’ cable from screws for unlocking mechanisms. the hooks of the rear cover. Use a Philips-head (No.1~4 screw size=M4x10;... - Page 7 Remove the Mylar from the hooks of the main chassis module. Disconnect the panel lamp cable from connectors. Use a Philips-head screwdriver to remove 4pcs screws for unlocking the main chassis with panel. (No.1~4 Screw size=M3x4, Torque=5±0.5kgfxcm) Use a Philips-head screwdriver to remove 8pcs screws for unlocking power board and interface board.
- Page 8 3.2 Assembly SOP Place a main bracket chassis base on a protective Take 1pcs mylar to insert the hooks of the main cushion, then paste 7pcs silicon sheet on the correct bracket to cover the power board. positions as the picture below shown. Use a Philips-head screwdriver totighten 2pcs screws for locking the AC power outlet.
- Page 9 Turn over the main chassis, then connect the EDP cable to the connector of the panel module. Move the front bezel with function key board close to the panel module, then lift up the panel and assemble the front bezel with it. Use a Philips-head screwdriver to tighten 2pcs screws for locking the front bezel with the assembled unit.
- Page 10 Take 1pcs rear cover, then locate the USB board unit Put down the rear cover on the assembled unit and to the hooks of the rear cover, then use a Philips- push the rear cover on the positions marked as head screwdriver to tighten 1pcs screw for unlocking No.1~4 in priority order for mechanisms the USB board unit with the rear cover.
-
Page 11: Troubleshooting
4. Trouble Shoo ng...
Need help?
Do you have a question about the PA279CRV and is the answer not in the manual?
Questions and answers