Remote Control - HOMCOM 820-251V80 Assembly & Instruction Manual

OPERATING INSTRUCTIONS:
● Before inserting the plug into an electrical outlet, make sure that the electrical supply in
your area matches that on the rating label on the unit.
● When plugged in, turn on the Main power switch at the back of the unit.
● When in Standby mode, only the switch
touch, and the LED display shows the room temperature. Press
of the control panel or remote control.
a) Low Power: 750W (Press "
b) High Power: 1500W (Press "
c) TIMER: Press "
itself off (From 0 hour – 8 hours)
d) + , - : adjust room temperature only by remote control.
● Temperature setting from 50-95 F. "+" to increase the desired temperature and "-" to
decrease the desired temperature. (On Remote control only)
e) Osc: Press " " to activate oscillation. Press it again to cancel.
f) Press to turn off the heater, the unit will keep working 30 seconds of cool air after
turn off it . this design can protect item use longer.
Warning: The heater will remain hot for some time after it is turned off; handle with
care.

REMOTE CONTROL

The remote control uses on button cell battery, type CR2025(3V).To remove the battery
carriage use your thumb to squeeze the release tab to the right and then pull the carriage
out. Place the battery into the carriage and slide the carriage back into the remote. See
Fig.1. We recommend the use of a Lithium-ion battery for longer use.
NOTE: Follow battery disposal instruction on battery packaging, or contact your local
safety council for safely disposal of batteries.
Before using the remote control, you must remove the insulating film as shown in the
figure below.
1. All functions performed with remote control work identically to the heater control panel.
2. Aim the remote control at the heater control panel to operate the heater.
" to switch it)
" to switch it)
" button repeatedly to set a period after which the heater will turn
O
on the control panel will respond to your
2
to access the rest