PowerTec T-Track Fence Cap and Stop Kit Instruction Sheet

INSTRUCTION SHEET
T-Track Fence Cap
and Stop Kit
WARNING
For your own safety, read the machine's instruction manual
before using any accessory. Failure to heed these warnings may
result in serious personal injury and damage to the tool and
the accessory.
• Before using the T-Track Fence Cap and Stop Kit, read and
follow all instructions and safety information provided.
• Always keep hands clear of the blade, cutter, sanding disc/belt.
• Before making adjustments to the T-Track Fence Cap
and Stop Kit, turn off the power, allow the blade, cutter or
sanding disc/belt to come to a complete stop and unplug
the machine.
• Before turning on the power after adjustments, ALWAYS verify
there is a safe clearance between the blade and fence.
UNPACKING CONTENTS
NOTE: Check for shipping damage. Check immediately whether
all parts and accessories are included.
ITEM DESCRIPTION
A
Flip Stop (to be assembled with B through E)
B T-Bolt
C Knob (for T-Bolt)
D Flip Stop Arm
E Screw-on Knob
F 24" T-Track Fence Caps
G
128" RL/LR Self Adhesive Tape Measures
Figure 1
WARNING
Risk of accidental starting and serious personal injury. Unplug the
machine before attaching the T-Track Fence Cap and Stop Kit.
THE T-TRACK FENCE CAP AND STOP KIT
The T-Track Fence Cap (F) is an aluminum extrusion with a
universal T-slot on top for attaching a Flip Stop (A). There is a
flat recessed area for installation of the Tape Measures (G).
Figure 2
Assemble The Fence Cap:
Figure 3
QTY
1
1
1
1
1
Figure 5
4
2
Model No. 71742
Figure 4
1. The Fence Caps are designed
for a 3/4" thick fence.
Minimum 1-3/4" Height.
Maximum 3" Height.
2. Use the groove on the back
of each Fence Cap as a drill
guide for screw placement.
3. Use an 1/8" drill bit to drill
pilot holes 1" from each end.
Secure with 3/4" wood screws
(not included). Evenly space
two more 3/4" wood screws.
Four per 24" section.
4. Next, attach the Fence to a
support board. Attach that
assembly to the workbench.
23-0711